您要查找的是不是：
- Coning compensate algorithms are effectual both in rotation vector method and Euler angles method, and besides, compensate precisions are equivalent when oscillation angles are small. 圓錐補償算法在旋轉矢量方法和歐拉角方法下均有效，并在振動角較小時補償效果一致。
- The attitude algorithm based on rotation vector is an effective method to reduce the coning error in strapdown attitude calculation. 基于等效旋轉矢量的姿態算法是減小捷聯姿態計算中不可交換性誤差的有效方法。
- Using sine rotation vector as an indication method, the influences of datum beam length, sliding boots gap and length on frequency characteristics of the beam are analyzed. 利用正弦量的旋轉矢量的表示方法，分析基準梁長度、滑靴的間距和滑靴長度對基準梁的頻率特性的影響。
- The results show that the vector method of single plane is valid. 通過砂輪機轉子動平衡介紹了羊平面平衡向量法的步驟。
- The Kepler problem is solved by vector method and without the Binet equation. 直接利用矢量解法求解開普勒問題;不必借助于比奈方程.
- So the paper introduces the rotation vector algorithm into GFSINS, and in allusion to its characteristics to resolve the problems, which come out from the application. 因此,本文針對無陀螺捷聯慣導系統的特點解決在無陀螺捷聯慣導系統應用旋轉矢量法所需到的問題。
- Establish displacement vector equation of mechanism using vector method to infer the speed and the acceleration vector equation. 運用矢量法建立機構的位移矢量方程,推導出速度、加速度矢量方程。
- The formulas of lateral area, surface area, and volume of pyramid can be given by Vector Method. 立體幾何中棱錐的側面積、全面積、體積公式都可用向量方法給出。
- The kinematics mathematic model of lifting mechanism of vehical tail-lift is built by plural vector method. 摘要采用復數向量法建立了車用起重尾板起重裝置運動學的數學模型，分析了該舉升機構運動的特點。
- The conventional PTS method of reducing OFDM signal’s PAPR has large computation complexity because of the computation of all sets of the phase rotation vectors. 傳統的降低OFDM信號峰均比值的部分傳輸序列(PTS)方法需計算全部相位旋轉因子序列所對應的峰均比值，因而計算復雜度很大。
- Geometric vector method based on triangular vector loop is proposed for position analysis of planar complex mechanisms. 摘要針對平面復雜機構位置分析，提出基于三角矢量回路的幾何向量法。
- In the paper, the rotation vector algorithm for SINS attitude updating is introduced, and the algorithm drifts of mathematical platform caused by the base coning motion are analyzed in detail as well. 介紹了捷聯慣導姿態更新算法中的旋轉矢量算法,分析了錐運動環境下數學平臺的算法漂移,提出了通過求解矛盾方程組實現四子樣旋轉矢量算法優化處理的新方法,并對單子樣、雙子樣、三子樣、四子樣的算法漂移作了對比計算。
- A theorem of composite of acceleration of a particle is proved by vector method when carrier is in plane motion. 用矢量法給出牽連運動為平面運動時，點的加速度合成定理的證明。
- Application of vector method to problems involving parallelism, perpendicularity and division of a line segment. 應用向量方法以解平行，垂直及線段之分割等問題。
- Here the complex number vector method is used to analyze the direct and inverse kinematics of a kind of five-bar Cobot. 該文利用復數矢量法對一種五桿式人機合作機器人的運動學正、逆過程進行了分析,推導出其運動方程。
- The axial dispersion in chromatography models was discussed with vector method and the effect of diffusion on the bulk flow flux with its partial quantity form was pointed too. 用矢量方法討論了色譜模型中的軸向擴散項，指出軸向擴散項是擴散通量以分量的形式在主體流動通量上的頁獻。
- Recursive Frequency Selection of Rotation Vector 等效轉動矢量法采樣迭代頻率選取方法
- Build a PWM converter model after explaining the Simplified control theory so as to analyze the control method. And based on it bring forward a simple voltage space vector method. 摘要建立了一個PWM整流器的模型，在解釋簡化控制原理后對矢量控制的策略進行了分析。在此分析的基礎上提出了一種簡單的電壓空間矢量的算法。
- Both the phase gradient method (PGM) and the poynting vector method (PVM) for computation of angular glint of complex targets are discussed from polarization consideration. 摘要從極化的觀點出發討論了復雜目標角閃爍的兩種計算方法。
- rotation vector attitude algorithm 等效旋轉矢量
