您要查找的是不是：
- Study on welded joint strength of unequal strength base metals 母材不等強焊接接頭強度研究
- High Temperature Strength Test of Heat Resisting Steel FNA Combined Welded Joint 耐熱鋼 FNA 組合焊接接頭的高溫強度試驗研究
- Joint strength test for plaster board light steel profile system 紙面石膏板輕鋼龍骨系統接縫強度試驗
- In order to ensure the use safety of pressure container, we must test the welded joint angularity and stagger joint. 為了保證壓力容器的使用安全，必須檢測焊接棱角度和錯邊量。
- solder joint strength test 焊錫連接強度試驗
- Concrete bending tensile strength test machine. 混凝土抗折機。
- Metallographic analysis,tension test,fatigue test and SEM analysis were conducted on the TA15 titanium alloy welded joint. 對TA15鈦合金板材電子束焊接試樣進行了金相分析和靜力試驗、疲勞試驗和掃描電鏡(SEM)分析。
- The results show that the experimental and analytical methods are feasible for the study of strength and ductility of laser welded joint. 結果顯示這些試驗分析方法對于研究激光焊接接頭強塑性是可行的。
- In this article tensile test,bending test and microhardness test were conducted on the laser welded joint of the steel sheet for automobile use. 對汽車用薄板的激光焊接接頭進行了拉伸試驗、彎曲試驗及顯微硬度分析等。
- The equipment of ultrasonic peening for increasing fatigue strength of a welded joint is imposed and a corresponding ultrasonic peening prototype is manufactured. 對超聲波沖擊以提高焊接接頭疲勞強度的裝置進行了研究，研制出一臺可用于實際沖擊處理的樣機。
- Keywords Welding joint Strength mismatching J integral Failure assessment curve; 焊接接頭;強度組配;J積分;失效評定曲線;
- Standard forms for concrete bending tensile strength test cube. 混凝土抗折試模。
- Distribution of Mg in melt pool and its effects on mechanical properties of welded joint were investigated by EDX analysis, microhardness test and tensile properties test. 通過對焊縫的能譜分析、顯微硬度試驗和拉伸性能試驗，研究了Mg元素燒損后在熔池內的分布規律及對焊后力學性能的影響。
- Standard forms for concrete compressive strength test cube. 混凝土抗壓試模。
- The stress corrosion cracking(SCC)behavior of X70 steel welded joint was investigated in a near-neutral pH solution by fluctuant slow strain rate test(F-SSRT). 研究了波動頻率對X70管線鋼焊接接頭在陰極電位下的近中性介質中慢應變速率應力腐蝕開裂(SCC)行為。
- Standard forms for grout compressive strength test cube. 砂漿試模。
- Weldbonding experiments were performed and the results show that weldbonding technique can improve the strength and fatigue life of the weld joint. 同時參考分析結果進行粘接點焊的試驗研究，表明粘接點焊可以顯著提高結構的強度和疲勞壽命。
- Fig.6 The effect of heat input on the UTS of the TIG welded joints. 圖6線能量與鎢極氬弧焊焊接接頭極限抗拉強度的關系。
- For flexural strength test of cement specimen and other nonmetallic material. 用作水泥或其它非金屬脆性材料試塊的抗折強度測定。
- The distribution of residual stress of weld joints is analyzed. 并分析了焊接接頭殘余應力的分布規律。
