您要查找的是不是：
- In this paper, we propose a new array shape calibration method that borrows the idea from RCB, i.e., we estimate the steering vector and further deduce the positions of hydrophones. 借用RCB的思想,提出一種新的陣形校正方法,該方法對導向矢量進行估計,然后用估計的導向矢量推導出陣元的位置。
- We can use the full 2-port calibration method to achieve the best measurement when we measure the RF&MW devices with vector network analyzer，but it is only applied to measure the insertable devices. 利用矢量網絡(luò )分析儀測量射頻微波器件時，使用全二端口校準方法可以獲得最高的測量精度，但是全二端口校準只適用于插入式器件的測量。
- APPLICATION OF "CORE CALIBRATION METHOD" IN LOG INTERPRETATION MODEL. 巖心刻度法在測井解釋模型中的應用
- The calibration method can also be used for other micro-accelerometers. 標定方法也適用于其他類型加速度傳感器。
- This paper mainly introduces the calibration method of piezoelectricity pressure sensors in the pressure field testing. 介紹壓力場測試中所采用的壓電壓力傳感器的標定方法。
- A new camera calibration method using the CMM and the devices by hand was proposed. 完成單個攝像機主要內部參數的標定工作，提出了利用光筆和三坐標測量機完成標定任務的巧妙辦法；
- Brief discussion is given to calibration method of water j acket level in flue duct of copper smelting converter. 簡要地探討了煉銅轉爐煙道水套水位標定方法。
- The kinematics calibration method was studied based on the 6-TPS type Parallel Kinematics Machine (PKM). 摘要以6-TPS型并聯機床為對象，研究了并聯機床運動學標定方法。
- The calibration method of pipe wall coefficient of chlorine modelfor large-scaled WDS is studed. 2)對供水管網管壁反應系數進行校核研究。
- The kinematics calibration method was studied based on the 6-TPS type Parallel Kinematics Machine(PKM). 以6-TPS型并聯機床為對象,研究了并聯機床運動學標定方法。
- This paper puts forward a kind of calibration method for triangulation based on non-diffracting grating. 提出了一種基于無衍射光柵的三角測量的定標方法。
- Finally, the correctness of the calibration method and the reliability of the measure precision were validated. 并通過對標定結果的分析，驗證了標定方法的正確性以及精度的可靠性。
- Finally, the correctness of the calibration method and the reliability of the measure precision were val... 并通過對標定結果的分析,驗證了標定方法的正確性以及精度的可靠性。
- A camera calibration method based on the Iterated Extended Kalman Filter (IEKF) was proposed in this paper. 本文提出了一種基于迭代擴展卡爾曼濾波的攝像機標定方法。
- A calibration method of vision sensors based on a planar gridding target was presented. 提出了一種基于平面網格靶標的視覺傳感器的標定方法。
- We provide conditions under which the regression calibration method outperforms complete case analysis. 本文也進一步引出加權的迴歸校正法，以使參數的估計最有效。
- This paper presents a new model that laser projector and CCDs are detached and calibration method is introduced. 將激光器與CCD攝像機分離,并給出了標定方法。
- The transformation matrix,calibration method and precision of the coordinate system were investigated. 對兩坐標系的轉換矩陣、標定方法和標定精度進行研究。
- It is shown that the proposed measuring and calibration method can effectively eliminate the scattering matrix decorrelation cau... 研究結果表明在一定信噪比條件下,該測量和校準方法可以有效地消除因目標運動而導致的散射矩陣兩列元素去相關。
- This paper introduces the calibration system and static and dynamic calibration method of an engine intake manifold pressure sensor. 介紹了發動機進氣歧管壓力傳感器的標定系統和傳感器靜、動態標定方法。
