您要查找的是不是：
- Please check whether the open pressure of safety valve is in good condition. 請檢查安全閥的開啟壓力是否正常。
- Opening Pressure of Fuel Injector: 15,000–15,8kPa (2175–2291 psi). 燃油噴射器打開壓力： 15;000–15;8kPa (2175–2291 psi).
- One, why is a small two-seater valve opening oscillation work easier? 為什么雙座閥小開度工作時容易振蕩？
- The vacuum valve opens to admit air. 真空閥開啟以補充空氣。
- The failure of valve opening sensor would cause valve management of DEH system working confusedly,and result in large scale change of turbine power in the case of governing stage pressure loop idle. DEH系統中閥位傳感器的故障會(huì )給閥門管理帶來混亂，特別在調節級壓力回路未投入的情況下會(huì )引起汽機功率的較大變化。
- When the coid is powered the valve opens (t< 1s). 當切斷電流時，閥門迅速關閉。
- By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV). 根據黑箱理論提出將閥前壓力、閥前過冷度、閥后壓力和膨脹閥流通面積作為膨脹閥流量系數的影響參數。
- A type of engine fuel injector of 12-cylinder was set up to form five kinds of fault,they are nozzle blockage,needle valve clip,spring break,very low and very high pressure of needle valve open. 某12缸發動機噴油器上設置的5種故障分別是噴孔堵塞、針閥卡滯、彈簧斷裂、針閥開啟壓力過低和針閥開啟壓力過高。
- As DME is easy to atomize and evaporate, the nozzle opening pressure was lowered. 試驗結果表明，該燃料的噴射與燃燒過程明顯不同于柴油。
- So the exhaust valve opens before BDC and closes after TDC. 因此排氣門在下止點之前打開，在上止點之后關閉。
- The penetration and flabelliform angle increase as the opening pressure increases. 隨著啟噴壓力的增加，噴霧貫穿距和扇形角也相應增大；
- If the pressure builds up excessively, the pressure valve opens to relieve the pressure. 如果油箱內壓力過高，則壓力閥開啟，以降低壓力。
- REPAIR THE OPEN PRESSURE SWITCH SENSE CKT BETWEEN SOLENOID PACK AND TCM CONNECTORS. 維修在電磁組和TCM接頭間斷開的壓力開關感知電路。
- The direction of fuel spray after impingement and opening pressure of nozzle were important factors to influence fuel and air mixing and burning process. 另外撞擊反彈方向和噴油壓力等也是影響混合氣形成和燃燒的重要因素。
- Regeneration opportunity and regeneration valve opening of DPF are controlled by 80C196KB single chip microprocessor. 采用80C196KB控制柴油機微粒過濾器再生時機和再生調節閥開度。
- The valve opens for tank discharge when tank head pressure is greater than valve inlet pressure. 當容器水頭壓力大于閥門進口壓力時，閥門開啟進行容器排放。
- Locate percentage of valve opening on the bottom scale of Flow Characteristic Curve (Fig. 6). 從流量特性曲線（圖6）的底部刻度找出閥門開啟度百分比。
- If closed port pressure exceeds open pressure ,ball may be forced off of the seat ring whhich could allow mixing from all ports. 如果關閉端口壓力超過開啟端口壓力，球可能會(huì )被壓出能夠混合所有端口流體的閥座環。
- For snap action, the main valve opens rapidly at set pressure and achieves rated relieving capacity at relieving pressure. 對于快動式先導器，主閥門在達到設定壓力時快速打開并且在泄放壓力時達到額定排放量。
- For modulating action, the main vent valve opens gradually with increasing pressure and achieves rated relieving capacity at relieving pressure. 對于調制式先導器，主閥門將隨壓力增加而逐漸打開，在泄放壓力時達到額定排放量。
