您要查找的是不是：
- Can check ADDRESS BUS or DATA BUS circuit open short or not. 可知ADDRESS BUS或DATA BUS信號本身有無開短路情形。
- The microprocessor uses the address bus to locate data stored in memory. 微處理機使用地址總線設定在存貯器中存貯的數據的地址。
- A memory map is the addressing plan for the address bus bits. 存貯器布局就是地址總線各位的尋址平面圖。
- So that the entire DMA transfer address becomes available on the address bus. 以使整個DMA傳輸地址有效。
- Address Bus:Locates data stores in the memory,input port, or output port. 地址總線：確定數據在存儲器，輸入口或輸出口中的存儲位置。
- A memory address consists of binary data being output on an appropriate bus which we call the address bus. 一個存儲器地址是由輸出到適宜的總線上的二進制數據所組成。這個總線我們稱為地址總線。
- The system bus is divided into three logical functions; the address bus, the data bus and the control bus. 系統總線的功能在邏輯上被劃分為三部分：地址總線、數據總線和控制總線。
- The system bus is divided into three logical functions: the address bus,the data bus and the control bus. 系統總線的功能在邏輯上被劃分為三部分：地址總線、數據總線和控制總線。
- The power dissipated by the address bus is the important power dissipation source of the DSP. 地址總線的功耗是DSP功耗的重要來源。
- A 'real' address, the value that must be placed on the system address bus to select a physical memory bank or device. 物理地址：真實的地址，其值必須被置于系統地址總線中用于選擇物理存儲位置或者設備。
- The address is transmitted to the memory through a set of parallel wires called an address bus. 向存儲器傳送地址是經過一組為地址總線的并行導線進行的。
- The actual address that is placed on the address bus when accessing a memory location or register. 當訪問內存位置或寄存器時,在地址總線上的真實的地址。
- A novel adaptive-offset bus encoding method was presented for reducing the power dissipation of highly capacitive memory address bus. 為了降低大負載地址總線的功耗;提出了一種新的低功耗自適應偏移量總線編碼方法.
- The system controlling logic, multiplexing data bus and multiplexing address bus have been designed. The simulations have passed. 完成了系統的控制邏輯、數據總線復用和解碼部分的地址復用器的設計，仿真并通過。
- During normal 80X86 operation (AEN=0), latches A and C and the multiplexer (E) provide address bus bits A19-A16 and A7-A0. 在80X86通常的操作情況下，地址總線的第0-7位和第 16-19位由鎖存器A，C和多路復用器E提供。
- The address bus is used by the processor to select aspecific memory location or register within a particular peripheral. 地址總線被處理器用來選擇在特定外設中的存儲器地址或寄存器。
- Phone mode, modem connection status physical address A 'real' address, the value that must be placed on the system address bus to select a physical memory bank or device. 物理地址:真實的地址,其值必須被置于系統地址總線中用于選擇物理存儲位置或者設備。
- The address bus specifies the memory locations (addresses) for the data transfers. 地址總線為數據傳輸指明內存位置（地址）。
- The address bus specifies the memory locations(addresses) for the data transfers. 地址總線為數據傳輸指明內存位置（地址）。
- When the processor wants to read (write) the contents of a memory location or register within a particular peripheral, it sets the address bus pins appropriately and receives (transmits) the contents on the data bus. 當一個處理器想去寫（讀）某一特定外設中的存儲器地址或寄存器中的內容時，處理器設置地址總線并在數據總線上接收（傳輸）內容。
