您要查找的是不是：
- Acetonitrile was selected as porogen (solvent). 選擇乙腈為成孔劑（溶劑）。
- Nano-porous fluoro polymer fiber mats with PVP K30 used as porogen has highest tensile strength. 以PVP K30為致孔劑所得含氟聚合物納米多孔納米纖維膜的拉伸強度最高。
- A novel method was developed to prepare porous chitosan membranes with dibutyl phthalate as the porogen. 以鄰苯二甲酸二丁酯為致孔劑,制備了多孔殼聚糖膜。
- The effect of the amount of porogen, crosslinker and MAA on the latex morphology was studied. 系統研究了致孔劑用量和交聯劑對乳膠粒形態的影響。
- The influences of pretreatment of capillary and porogen solvent on porous structure and permeation were investigated. 實驗考察了毛細管內壁處理方法，致孔劑組成對整體固定相孔結構和通透性的影響。
- Then the MIP coating was copolymerized and anchored onto the surface of the silica monolith. Acetonitrile was selected as porogen (solent). 然后分子印跡化合物通過與硅膠整體柱上的烯基發生共聚反應從而固定在其表面。選擇乙腈為成孔劑（溶劑）。
- The effect of porogen,mass ratio of the two networks and crosslinking degree of the second networks on the pore structure of the PDV. 交聯劑和致孔劑是影響樹脂合成的關鍵因素,通過改變它們的種類和比例可以得到不同孔結構的吸附樹脂。
- When the content of CMCS is 40% and the ratio of composite and porogen is 1:1 the porosity ratio is about 75% and the compressive strength can exceed 21MPa which should be desirable for bone tissue engineering. 當復合材料中CMCS含量為40%25,復合材料/造孔劑的質量比為1:1時,多孔材料的孔隙率接近75%25,其抗壓強度可達21MPa以上,可以滿足骨組織工程支架材料的要求。
- In this work, the PSt and P(St-MAA) latex particles with porous and nanocapsule structure were successfully synthesized via miniemulsion polymerization using different alkane as the porogen. 本文分別以不同的烷烴作制孔劑，用細乳液聚合法成功制備了具有多孔和微膠囊結構的聚苯乙烯和苯乙烯/甲基丙烯酸共聚微球。
- Keywords molecular template polymer;non-covalence method;porogen;review; 分子模板聚合物;非共價法;致孔劑;綜述;
- tretic 孔生[產孢]的
- tretic conidium 孔出分生孢子
- porogenous (分生孢子)孔生的
- porogen 致孔劑
