您要查找的是不是：
- tape drive controller 走帶控制器
- Select a tape drive to use for restore. 選擇用來還原的磁帶機。
- Improperly linked tape drive channel. 磁帶驅動器頻道鏈接不當。
- To mount(a magnetic tape) onto a tape drive. 裝磁帶把（磁帶）裝入錄音機
- Work with the change control board. 變更控制委員會(huì )是審批變更的權力機構。
- Is isolated from the drive control circuit. 與驅動控制電路隔離。
- Cut the GREEN jumper wire on the Control board. 剪掉（切斷，停止）控制板上綠色跳線。
- The sluices are worked from the control board. 閘門是由控制臺操縱的。
- The operation was aborted, even if the tape is in the tape drive. 作業已結束,即使磁帶已位于磁帶機上。
- The sluices are worked from the control board . 閘門是由控制臺操縱的。
- Remember to clean the tape drive before the next server backup. 請記住在下一次服務器備份前清洗磁帶驅動器。
- A device containing a tape drive, magnetic head, and associated controls. 包括磁帶驅動器、磁頭和相應控制器的一種裝置。
- You can control whether a backup tape is unloaded automatically from the tape drive after a backup or restore operation. 您可以控制在備份或還原操作后備份磁帶是否自動從磁帶機卸載。
- No power to control board or diagnostic light burned out. 控制板上沒有電源,或診斷燈燒壞。
- To back up to tape, you must specify the device name of the tape drive. 要備份到磁帶,必須指定磁帶驅動器的設備名。
- Carefully unsolder the battery from the control board. 小心地拆開焊合之物來自控制董事會(huì )的電池。
- The destination can be either a file name or a tape drive device name. 目標可以是文件名或磁帶驅動器設備名。
- If an error occurred on a tape device, you can clean or replace the tape drive. 如果磁帶設備發生錯誤,可卸下或更換磁帶機。
- Never place a tape drive on the same SCSI bus as disks or a CD-ROM drive. 永遠不要將磁帶機與磁盤或CD-ROM驅動器放置在同一個SCSI總線上。
- The hardware of control board is made up of CPU(8 9C51) and CPLD(EPM71 28SLC8). 系統硬件以CPU(89C51)和CPLD(EPM7128SLC8)為基礎.
