您要查找的是不是：
- The paper analyses the stress wave propagating in a variable section bar using HONDO finite element computer program . 利用HONDO有限元程序對應力波在變截面桿中的傳播進行了分析。
- Acoustic emission (AE) is stress wave produced when the materials are distorted, or under the outside load. 眾所周知,聲發射(AE)是材料在受到形變或外力作用時,迅速釋放能量而產生的瞬態應力波,是進行結構診斷的重要依據。
- The mechanism of spallation is analyzed as a result of the interaction of the unloading wave and reflected stress wave. 分析了層裂機制，得出靶材是在卸載波及被反射的壓力波的共同作用下發生層裂;
- The paper analyzes the reasons for emulsion explosive's passivation by the action of blasting stress wave. 文中分析了爆炸應力波作用致使乳化炸藥鈍化的原因。
- It is shown that the irregularity of the joint surface apparently affects the stress wave transmission. 研究結果表明：節理面不規則結構明顯地影響應力波的傳播性質。
- This paper presents a signal de-noising method using wavelet analysis in stress wave detection. 介紹了一種適合于管道應力波檢測的基于小波變換的去噪方法。
- The interreaction between the weight hammer and the explosive sample is analysed making use of the stress wave theory. 從剛體動力學觀點將這種相互作用簡化為二階系統,可得到一組關于應力、應力率和應力脈沖寬度的表達式。
- Structures, cutting mechanism and stress wave theory of the tunneller a re presented and analyzed. 文章對這種掘進機的結構、截割機理及應力波理論進行了介紹和分析。
- The process problems of composite structures using interference fit technology can be solved by use of Stress Wave Riveting (SWR). 分析了復合材料結構采用干涉配合技術存在的工藝困難，利用應力波鉚接設備對碳纖維復合材料進行了干涉配合鉚接試驗，并對鉚接質量進行了檢測分析。
- It is the macro effect of accumulative micro fracture in all period of time that spallation failure is induced by reflection of stress wave emerges. 應力波反射誘發層裂過程的發生，是各個時刻不同加載條件下微破裂累積的宏觀體現。
- The control equation of stress wave propagation in timbers is given in cylindrical polar coordinates,and the governing equations of the three comp... 用云杉作為一個實例;分析了其彈性常數;討論了在對稱和非對稱情況下應力波的傳播情況.
- The effect of growth rate and latewood percent on stress wave modulus of elasticity was more obvious than that on vibration modulus of elasticity. 應力波測試的動彈性模量和生長率及晚材率關系密切,超過振動測試的彈性模量和生長率及晚材率關系。
- This paper analyses the producing causes of stress wave,introduces the vibrating technique and hazard of stress wave,puts forward the solution mode. 分析輸送帶中張力波產生的原因,介紹張力波振蕩的機理,指出振蕩的危害性,提出解決的方法。
- In this paper, the attenuation phenomenon of stress wave transmitted through a fractured rock specimen has been studied by the method of the Split-Hopkinson bar. 本文用 Split-Hopkinson 壓力桿裝置研究了應力波通過破裂巖石試件的衰減現象。
- The plane-section assumption was not congruous in low strain dynamic tests on pipe piles,so the propagation of stress wave couldn't be expressed by 1D wave equation. 管樁低應變檢測時,平截面假定并不滿足,應力波的傳播不能簡單地用一維波動方程描述。
- Stress can be the undoing of so many fine players. 緊張可能是這許多優秀選手失敗的原因。
- A mechanical model of impact truing was set up based on the theory of impact dynamics and stress wave spreading, and stress distribution was described accurately. 以沖擊動力學和應力波傳播理論為基礎，建立了沖擊整形的力學模型，較為準確地描述了水泥環中的應力分布。
- In order to deduce the static resistance from the result of a STN test, many interpretation methods had been developed, based on the lumped mass model or the stress wave model. 目前常用于詮釋靜動態載重試驗的方法有單質點模型詮釋法、分段卸載點法與單向度應力波傳法。
- The position where stealing happened is derived by calculating the difference between the times at which the stress wave reaches the two adjacent detection transducers. 在盜油實時監測時,利用沖擊激勵產生的應力波到達兩個檢測傳感器的波達時刻的差對沖擊激勵點進行定位。
- With one-dimension stress wave theory,the principle ofinfluence of soft stratum on blasting effect taler a comparatively simple geological condition is explained in the paper . 本文就一種較簡單的地質條件，用一維應力波理論，解釋了軟弱帶對爆破效應的影響原理。
