您要查找的是不是：
- Bcc-Fe(Si) solid solution crystalize preferentially at normal pressure while at high pressure DOe type Fe3B and bcc-Fe(Si) will form simultaneously. 常壓下晶化時,bcc-Fe(Si)固溶體相先形成; 77kbar下晶化時,DOe型Fe_3B與bcc-Fe(Si)固溶體相同時出現。
- solid solution crystal 固溶體晶體
- A solid solution of iron and up to 1 percent of carbon, the chief constituent of hardened carbon tool steels. 馬氏本，馬登斯體一種由鐵和高達百分之一的碳組成的溶液，是硬化碳工具鋼的主要成分。
- The results show that with the increase in milling time,the crystal sizes of W-Cu milled powder will be finer,while the undersaturation solid solution wi. 結果表明,隨著球磨時間的增加,鎢銅球磨粉末晶粒尺寸得到細化,且有不飽和固溶體產生;燒結合金晶粒尺寸長大,孔洞減少,相對密度增大接近全致密。
- Single crystals of KTi 1- x Sn x OPO 4 solid solutions and KSnOPO 4 were grown by using flux method,and their structure and physical properties were studied. 采用熔鹽法生長了一系列磷酸氧鈦錫鉀單晶體并測定了其晶體結構和相應的物理性質。
- XRD spectra show that the bulk GaN particles are wurtzite structure, and the NC GaN has small domain size and the structure of solid solution phase. XRD結果顯示經由氣凝法合成前后氮化鎵均為一六方晶系結構，利用塊狀氮化鎵生成的奈米粉體粒徑微細且是一種固溶相結構。
- A solid solution of iron and up to1 percent of carbon, the chief constituent of hardened carbon tool steels. 馬氏本，馬登斯體一種由鐵和高達百分之一的碳組成的溶液，是硬化碳工具鋼的主要成分
- A nonmagnetic solid solution of ferric carbide or carbon in iron,used in making corrosion-resistant steel. 奧氏體一種非磁性的固狀可溶性含鐵碳化物或含碳鐵，用于制作不銹鋼
- A nonmagnetic solid solution of ferric carbide or carbon in iron, used in making corrosion - resistant steel. 奧氏體一種非磁性的固狀可溶性含鐵碳化物或含碳鐵，用于制作不銹鋼
- A nonmagnetic solid solution of ferric carbide or carbon in iron,used in making corrosion - resistant steel. 奧氏體一種非磁性的固狀可溶性含鐵碳化物或含碳鐵，用于制作不銹鋼
- CIG precursor film is composed of Cu11In9 matrix phase. Ga exists mainly in solid solution by substituting In. CIG前驅膜是以Cu11In9為基礎相,Ga原子主要是以替代In原子的固溶體形式存在。
- The solid solution of Sr_(1-x)Ca_xCuO_2 is investigated by means of XRD,EPMA and EDAXmethods. 本文用 XRD、EPMA、EDAX 等方法;研究了 Sr_(1-x)Ca_xCuO_2 固溶體.
- When ?x?>0.6, some TiO?2 enter CeO?2 lattice, and a CeO? 2-TiO?2 solid solution formes. x>0.;6時;一些TiO2已經進入了CeO2晶格;形成了Ce Ti固溶體。
- However Li_(14)Zn(GeO_4)_4 solid solution, being very sensible to CO_2 and H_2O,is unsta-ble in air. 但Li_(14)Zn(GeO_4)_4固溶體不穩定,在空氣中對CO_2和H_2O很敏感。
- Ti43.5V49Fe7.5 and Ti46V44Fe10 alloys consist of a single solid solution phase with BCC structure. 而Ti43.;5V49Fe7
- The crystallization process of BHT belongs to the cooling solution crystallization processes, which uses ethanol as the solvent. BHT結晶采用乙醇作為溶劑。對不同濃度的乙醇,改變溶質與溶劑的物料配比,測定了BHT溶液的出晶點溫度。
- The iron phase of Portland cement clinker is a member of continuous solid solution between C2F-C6AF2-C4AF-C6A2F. 硅酸鹽水泥熟料的鐵相，是C2F－C6AF2－C4AF－C6A2F連續固溶體。
- X ray diffraction analysis indicated that the materials prepared were single solid solution with layered structure. X-射線衍射分析表明,所得材料為層狀結構的單一固溶體相。
- It is shown that ZrB2 can form solid solution with TiB2 and redound to gain uniform grains. 研究結果表明,ZrB_2可以較好的固溶到TiB_2中形成固溶體,并有助于細化TiB_2晶粒。
- Research shows that the deformational suspensoid solid solution is stable with outstanding shear resistance. 研究表明：形變懸浮膠體聚合物溶液穩定性好、抗剪切性能強。
