您要查找的是不是：
- single ended output voltage 單端輸出電壓
- There is a lot more to good amplifier performance than output impedance. 除了輸出阻抗外，還有很多因素才能構成一部好的放大器。
- Normally a headphone amplifiers has a very low output impedance which gives the amp tight control over the headphone action. 翻一下：一般情況下耳機放大器為了對耳機控制有很低的輸出阻抗。
- However, many headphones have been sonically optimized to be driven by an output impedance of120 Ohm. 但是，許多耳機是在120歐姆的輸出阻抗下被調音的。
- These devices are up to 14 bit accurate with low aperture jitter and output impedance. 這些器件能達到14 bit精度并具有低孔徑抖動和輸出阻抗。
- It also has a low impedance, which assures that the typical unbalanced output impedance is between 100 and 1000 ohms. 同時它的低阻抗可以確保典型的非平衡輸出阻抗保持在100到1,000歐姆之間。
- The circuit in Figure 1 forms a highpass filter with the output impedance of the serial port and the capacitor. 如圖1電路形成帶串口和電容輸出阻抗的高通濾波器。
- After start-up, the low amplifier output impedance reduces reference current variations due to the current through R1. 完成啟動后，放大器很低的輸出阻抗將會(huì )降低因流經R1的電流不足以影響穩壓管上的電壓穩定性。
- Whether used single ended( RCA plugs) or balanced( XLR plugs), Amazon's smooth, crystal clear and authoritative sound is self-evident. 無論是使用單一插頭(CA)平衡插頭(lr)“亞馬遜”所表現的平滑柔順、瑩剔透與深具說服力的聲音，都是其映證。
- The replacement of BTL power amplifier with VCCS is adopted,to make the output impedance much higher and to overcome the anti-turning moment. 為此提出采用VCCS代替BTL功放來提高輸出阻抗,克服恢復力矩。
- Beth single end deuble fillet welds shell be es fellews unless etherwise shewn en the drewings. 除非圖上另外標明;所有焊縫均為連續全焊透焊接.
- For optimal signal transfer, the output impedance of the source should be equal to the characteristic impedance of the switch, the cables, and the DUT. 為了實現最優的信號傳輸，源的輸出阻抗應該等于開關、電纜和DUT的特征阻抗。
- Whether used single ended (RCA plugs) or balanced (XLR plugs), Amazon's smooth, crystal clear and authoritative sound is self-evident. 無論是使用單一插頭(RCA)或平衡插頭(XLR)，“亞馬遜”所表現的平滑柔順、晶瑩剔透與深具說服力的聲音，都是其映證。
- By using the wide-swing cascode current sources, the output impedance is increased without using too much voltage tolerance. CP電路中采用寬擺幅共源共柵電流源，增大了VCO控制電壓范圍；
- The SH-833's output impedance was on the high side, at 5 ohms from the 8 ohm transformer tap and 2.6 ohms from the 4 ohm tap. SH-833's輸出阻抗是偏高; 在5歐姆從8歐姆變壓器輕打和2.;6歐姆從4歐姆輕打
- New methods for calculating the mill outputs of single ended mills and double ended mills of BBD and FW types are proposed according to the results by the code. 采用優化求解程序，提出了新的單進單出球磨機、BBD和FW雙進雙出球磨機磨煤出力計算方法。
- The main OP in pipeline is realized by a two-stage cascode architecture with gain-boost OP.The large output impedance ensures this architecture a very high DC gain. 流水線中的運放采用帶增益自舉的兩級CASCODE結構實現，通過提高運放的輸出電阻來得到高的直流電壓增益。
- Portable Cassette Stove BDZ-160Product Name:Portable Cassette Stove BDZ-160Description:BDZ-160 is a single end gas cassette stove, with unique streamlined style. 便攜式卡式爐BDZ-160簡介產品名稱：?jiǎn)斡帽銛y式卡式爐BDZ-160。產品包裝：每箱/6個，單個以PP手提盒包裝；單重2.;0公斤，整箱毛重：約13
- In the single ended situation, the major disadvantage of this method is the average DC current that flows in the circuit must be supported by the transformer, making the transformer relatively large so that it does not saturate due to the DC only. 在單端電路中，主要的缺點是變壓器必須能足夠支持電路中的直流，這樣變壓器必須做得足夠大才不至于僅僅因為直流而發生磁飽和。
- The Model HP4191A High-frenquency Impedance Analyzer is used in measuring high-frequency characteristic of electronic elements and materials, and input or output impedance on the circuits and aerial. HP4 191A高頻阻抗分析儀是廣泛應用于電子元器件、電子材料的高頻特性測量 ,以及電路和天線輸入輸出阻抗的測量。
