您要查找的是不是：
- push-button telephone signal receiving circuit 按鈕話機信號接收電路
- Study on Weak Signal Receiving Circuit of SAW Gyroscope 聲表面波陀螺微弱信號接收電路研究
- signal receiving circuit 信號接收電路
- This paper introduces the application of AGC to the hydroacoustic signal receiver,and expounds in detail its working principle and circuit of hardware. 介紹了自動增益控制系統 (AGC)在水聲信號接收機中的應用 ,對其工作原理、硬件電路進行了詳細的論證
- In this paper,a detailed mathematical model for signal acquisition based on the analysis of the GPS receivers' circuit,average acquisition time and its variance are calculated. 在擴頻理論的基礎上;給出了GPS C/A碼接收機信號捕獲的數學模型;計算得出平均捕獲時間與捕獲時間方差;給出窄帶干擾下的接收機信號捕獲的仿真結果.
- The sensor uses infrared emitter and infrared phototransistor produced by SIEMENS to compose the infrared emission circuit and receiving circuit, and disposes receiving signal by single chip. 該傳感器采用西門子公司生產的紅外發射管和紅外接收管,組成紅外光發射電路和紅外光接收電路,并用單片機處理接收到的信號。
- Adds a satellite dish or similar signal receiving device to your network diagram. 在網絡(luò )圖中添加碟形衛星天線或類似的信號接收設備。
- Introduction : THE LNA is the block entrusted to amplify the weak signal received by the antenna in a reception system. 就是所謂的低噪聲放大器，它決定手機接收機的整體性能；
- And there is a signal receiver or dupe: the animal that cannot effectively distinguish between the model and the mimic. 擬態是無數代自然選 擇和遺傳變異的進化而獲得的有利特征的結果。比如，有些特征有利于偽裝，那么具有這 些特征的植物就比不具有的易于生存。
- The robot itself has CCD camera, microwave transmission device, wireless receival circuit and mechanic executable circuit. 該機器人控制系統包括了機器人本體、無線通信系統、微波通信系統、聲音遙控電路等部分。
- In this paper, a simple, practical remote signal receiver of high antiinterference is described. 介紹了一種簡單、實用、具有高抗干擾性的遠距信號接收器，較詳細分析了抗干擾電路原理。
- To understand the source of EMI andthe propagative way of EMI clearly the key protection of sensitive receiving circuit for EMI can be carried out. 通過對電磁干擾源的明確認識，對電磁干擾引入路徑的清楚了解，針對電磁干擾敏感的接收電路進行重點保護。
- The arc-ultrasonic signal received by sonic emission probe is used for detecting seam tracing. 利用聲發射探頭接收的電弧超聲信號進行焊縫跟蹤檢測。
- The system uses a powerful transmitting cir-cuit that transmits width-variable pulses, and a sensitive receiving circuit that offers quite wide frequency band. 該系統采用大功率、可變發射脈寬的發送電路，高靈敏度、寬帶的接收電路，能實現快速、動態、高分辨率的采集和成像。
- To send a signal to a process, the kernel sets a bit in the signal field of the process table entry, corresponding to the type of signal received. 為了向進程發送一個信號,內核在進程表條目的信號域中設置一個位,對應于收到的信號的類型。
- If you are having trouble placing the IR blaster on the set-top box correctly, try using a flashlight to locate the signal receiver on the set-top box. 如果將紅外遙控電纜正確放置在機頂盒上有困難,請嘗試使用閃光燈將信號接收器定位在機頂盒上。
- PCM code and decode system use LSIC called TP3067 as its Codec,DTMF signals receiving uses the chip of MT8870. The clock circuit needed in the design can be supplied by FPGA. PCM 編譯碼系統采用的是大規模專用集成芯片TP3067 編譯碼器,對DTMF 信號的接收采用的是MT8870 芯片。
- Make I/V transform for the current signal of 4~20mA coming from adjustor, then make A/D transform for the signal received just now. 對從調節器送來的4一20mA電流信號進行I瓜轉換，同時對轉換后的信號進行A/D轉換; 對經電位器反饋回來的閥位信號進行刀D轉換。
- The DWL system is composed of a transmission unit, a signal receiving unit, a signal acquiring unit and a processing control unit. 該激光雷達由激光發射單元、接收光學和后繼光學單元、信號探測和采集單元以及系統運行控制單元組成,后繼光路之間采用光纖導光、高低層分層探測等關鍵技術。
- First, the algorithm adopts the crosspower spectrum phase (CSP) algorithm to compensate time delay of the signal received by the microphone array. 該算法首先采用相位加權互功率時延估計法對麥克風陣列接收到的信號進行時延補償。
