您要查找的是不是:
- RSM could not register with service control manager. RSM無法在服務控制管理器上注冊。
- Could not register Service Control Handler. Operating system error = %1. 未能注冊服務控制處理程序。操作系統錯誤=%251。
- Could not register control handler with service controller %1. 無法注冊服務控制器%251的控制處理程序。
- Gets the service control handle for the service. 獲取服務的服務控制句柄。
- Handle to a service control manager database lock. 服務器控制管理器數據庫鎖的句柄。
- Structure that contains the service control handle for the service. 結構,包含服務的服務控制句柄。
- Unable to open service control manager database on %1. 無法打開%251上的服務控制管理器數據庫。
- Installation components register an individual service on the system to which it is being installed and let the Services Control Manager know that the service exists. 安裝組件在正在安裝到的系統上注冊一項單個的服務,并使“服務控制管理器”知道該服務的存在。
- The first notch of this digital filter can be programmed via the on-chip control register allowing adjustment of the filter cutoff and settling time. 此數字濾波器的第一個陷波可通過片內控制寄存器進行編程,以便對濾波器截止和建立時間進行調整。
- Click Close to close the Services control panel. 單擊“關閉”關閉“服務”控制面板。
- SPI register configuration platform achieve RS232 interface for data transmission equipment to the SPI bus to visit and control register of the base band signal processor. SPI寄存器配置平臺實現了RS232接口設備到SPI總線的數據傳輸,從而完成對OFDM基帶信號處理器中狀態寄存器的訪問與控制。
- The product code for the product of which this service control is a part. 包含此服務控制的產品的產品代碼。
- This paper shows in detail the workings of PCI9054, the configuration of its control register, and the writing of platform driver with API functions provided by the manufacturer. 利用PCI接口芯片的強大功能,本文提出了采用DMA模式雙向傳輸DSP平臺的高速數據,采用從模式傳輸初始化信息及配置信息等低速數據,并詳細介紹了PCI9054的工作方式,控制寄存器的配置以及調用廠商提供的API函數編寫平臺驅動程序。
- The Remote Installation service cannot update its service control point. 遠程安裝服務無法更新其服務控制點。
- The first notch of this digital filter can be programmed via an on-chip control register allowing adjustment of the filter cutoff and output update rate. 此數字濾波器的第一個陷波可通過片內控制寄存器進行編程,以便對濾波器截止和輸出更新速率進行調整。
- The service process could not connect to the service controller. 服務進程無法連接到服務控制器上。
- Could not set service status with service controller %1. 無法設置服務控制器%251的服務狀態。
- Allows declarative service controller permission checks. 允許聲明性的服務控制器權限檢查。
- A service control program is an application that uses SCM functions to control a service. 服務控制程序是使用SCM功能來控制服務的應用程序。
- You can also run DiagControl STOP in the collector's startup folder, or use the Service Control Manager to stop it. 您也可以運行收集程序的啟動文件夾中的DiagControl STOP或使用服務控制管理器來停止它。