您要查找的是不是：
- Separate trim panel from roof panel. 從車頂板分離裝飾板。
- Separate trim panel from roof panel . 從車頂板分離裝飾板。
- Install door waterdam and trim panel. 安裝車門擋水器和裝飾板。
- Remove the door module from the trim panel. 從飾板上拆卸車門模組。
- Separate lower B-pillar trim panel from B-pillar. 從B-柱上拆開下部B-柱飾板。
- Remove left cowl side trim panel. 拆下左儀表板側裝飾板。
- Install rear quarter trim panel. 安裝后三角飾板。
- Install the screw in the trim panel depression. 安裝飾板壓低處的螺釘。
- Disengage power mirror connector from trim panel. 從飾板上拆開電動視鏡接頭。
- Remove the trim panel and waterdam from door inner panel. 從內部?jì)x表板拆卸飾板和擋水器。
- Install screws attaching seat function switch to seat trim panel. 安裝連接座椅功能開關至座椅飾板的螺釘。
- Install the screws to attach the liftgate trim panel to the liftgate. 安裝連接升降閘門飾板到升降閘門的螺絲。
- Press the cowl top trim panel down until the snap clip retainers engage in the top of the instrument panel. 向下壓儀表板頂部飾板，直至夾扣定位器嚙合到儀表板頂部。
- Gently, pull trim panel downwarIf necessary rotate trim panel away from glass panel to release push-in fasteners. 輕輕地向下拉飾板。如果必要，從玻璃面板上旋去飾板，釋放按入式扣件。
- Pull the power mirror switch away from the trim panel far enough to access the wire harness connector. 從裝飾板拉電動視鏡開關足夠遠，找到線束接頭。
- The progress of the polyurethane rigid foam used in roof trimming of minicar is reviewed. 概述了微型汽車頂內飾用硬質聚氨酯泡沫塑料的狀況。
- Insert the solar sensor into the receptacle on the bottom of the cowl top trim panel and twist the sensor to lock it into place. 插太陽熱感知器進儀表板頂部飾板底部插座，并擰該感知器以鎖它到位。
- A rigid polyurethane foam for the roof trimming is prepared, and the moulding method is introduced. 制備了頂內飾用聚氨酯硬泡，介紹了硬泡頂內飾成型方法。
- Also please be advisedthat this sort of visually exposed connection will require the same sort of cover trim panel as shown for the typical condition. 同時請了解這種暴露在外的連接件如在典型情況下一樣需要有同樣的裝飾蓋板。
- She and I can't live under the same roof. 她和我不能住在一起。
