您要查找的是不是：
- supply and return water temperature 供回水溫度
- return water temperature is too high 回水溫度過高
- Correction for Formula on Supply and Return Water Temperature in Variable Temperature Control with Varied Flow 變流量質調節供回水溫度公式的修正
- Supply and Return Water Temperature Curve and Operation Ways of Central Heat-supply Network 集中供熱管網調溫曲線和運行方式
- The cooling water temperature is high. 冷卻水溫度高。
- Let me check the water temperature. 讓我試試水溫。
- Notice: 1) keep water temperature invariableness. 注意事項：1）注意保持水溫恒定。用藥期間亦然。
- You need to select the water temperature with the first button. 你可用第一個按鈕來調校水溫。
- The cooling water temperature cannot be measured accurately. 冷卻水溫度正確測定。
- Drench gush of water temperature adjustment again 20 seconds. 再把水調溫噴淋20秒。
- The configuration of supply and return water main and riser in the pipe well of the system is analyzed. 結合實例,分析了系統中管井內供回水干管、管的布置。
- Effects of water temperature on embryonic development of Onchidium sp. 水溫對石磺胚胎發育的影響。
- Points out problems in setting expansion joints for supply and return water risers. 摘要指出了在供回水立管中間設置伸縮節存在的問題。
- The higher the water temperature is, the stronger the tea aroma it will be. 水溫愈高香味愈足。
- Title： Effects of water temperature on embryonic development of Onchidium sp. 關鍵詞：石磺;水溫;胚胎發育;孵化出膜;停止發育
- In-house: For managing cost, many products return water there is glaze in the turn, or a pad that used difference of stretch small, sealed function. 內部：為了節約成本，不少產品返水彎里沒有釉面、或使用了彈性小、密封性能差的封墊。
- Water temperature is set by a single control which adjusts the water flow. 水溫由能調節水流的單一控制器來設定。
- The abuses existing in the original turbid return water disposal system, the necessity and the reformation by adapting [M+F] method were introduced. 分析了柳鋼中板廠原有濁環水處理系統中存在的弊端和進行改造的必要性以及應用[M+F]凈化處理方法進行的改造。
- Indirect connecting is diseconomy for low water temperature of heating network. 熱網供水溫度低間接連接不經濟。
- To whatever extent is practical, several orifices/traces shall be supplied from a local steam manifold and shall discharge to local return water / condensate manifold. 孔板/伴熱管應盡量從本地蒸汽集合管開始，并盡可能排入本地回水/冷凝液集合管。
