您要查找的是不是：
- For extrudates there are side crushing strength tests, bulk crushing strength tests, abrasion tests. 對擠條產品有側壓強度的測試，堆積強度測試和耐磨測試。
- How can we take that crush strength and back-calculate the maximum height to which the reactor can be loaded? 我們如何得到抗碎強度并反算出反應器所能裝載的最大高度呢?
- In selecting a refractory for a particular use, we should consider the texture, the crushing strength, and the chemical composition of the material. 為特定用途選擇耐火材料時，要考慮其質地、抗碎強度和成分。
- It has proved that the PU micropheres prepared by this method have high resistance,high crushing strength and good adsorbability. 證明了用本法所合成的PU微球有較好的抗耐性，較高的抗壓強度和較好的吸附性能。
- Crushing strength,bending strength,bulk density,thermal shock resistance and heat expansion coefficient ofthe samples prepared were tested. 為了比較2種制品,分別對其進行了抗壓強度、抗折強度、熱膨脹系數、熱震穩定性測試及微觀形貌觀察。
- The Water absorption (Wa), Porosity (Pa), Bulk density (D) and crushing strength, acid resistance, alkali resistance have been tested. 測試了樣品的吸水率、氣孔率、體積密度以及壓碎強度和耐酸耐堿性。
- The physical properties of catalysts such as specific surface area, pore volume, stacking density and crushing strength were tested. 測定了催化劑的比表面積、比孔體積、堆積密度和壓碎強度等物理性質參數。
- The typical product has the following physical properties: bulk density 0. 86 g/cm3, cold crushing strength 4. 2 MPa, flexure stre... 該制品具有隔熱性能好、使用溫度高、熱容小等特點,是間歇式窯爐輕質耐火內襯的理想材料,可替代同類型的進口產品。
- In selecting a refractory for a particular use, we should consider the texture, the crushing strength , and the chemical composition of the material. 為特定用途選擇耐火材料時，要考慮其質地、抗碎強度和成分。
- On the analytical foundation of the flat crush test of honeycomb paperboard, the crush strength and the method of cushion design of honeycomb paperboard were discussed. 摘要在分析蜂窩紙板平壓試驗結果的基礎上，討論了蜂窩紙板的壓潰強度和用能量吸收理論設計蜂窩紙板緩沖墊的方法。
- The use of POP colors also avoids issues involving melt fracture or excessive parison hang time and aids column crush strength. POP色料的使用還能避免涉及熔體破壞或過多的型坯停留時間，并且有助于推疊承壓強度。
- Influence preparation of parameters on crushing strength of the support for residue oil hydrodemetalation catalysts was investigated through experiments. 本文通過實驗，探討了制備條件對渣油加氫脫金屬催化劑載體機械強度的影響。
- Abstract: The crush strength of pressed pellets of capacitor grade tantalum powder which is used for making tantalum solid electrolytic capacitor was tested. 用電容器級鉭粉壓成適于制作固體電解電容器陽極的坯塊，壓縮測定其生坯強度。
- Two kinds of single briquette of different crush strength by thermo-gravimetry are studied, and the effect of crush strength on single briquette pyrolysis is gotten. 采用熱重法,對兩個不同煤種的單顆粒型煤在不同成型壓力下的熱解過程進行了研究,得到了成型壓力對單顆粒型煤熱解失重的影響規律。
- Crush strengths determined by hand-operated equipment are very much affected by the rate of force application. 手動操作裝置所測定的抗碎強度受外加力的速率影響很大。
- Vendors, in general, use hand-operated equipment for obtaining their average crush strengths. 售主們通常采用手動操作裝置取得他們的平均抗碎強度。
- It has good abrasion resistance, corrosion resistance, thermal shock resistance and high crushing strength, good, slag corrosion resistance, and is suitable for the zone which need good abrasion resistance in boilers. 該材料抗腐蝕性強、耐壓強度高、熱震穩定性好、耐磨性小、抗剝落，是鍋爐易磨損部位的最佳材料。
- His strength in a crisis is an ace in the hole. 臨危不懼是他的看家本領。
- This study amid to compare spray dried and milled L-leucine as lubricants for effervescent tablet formulations with regard to their lubrication properties, disintegration time and crushing strength. 本研究旨在比較以噴霧乾燥和磨粉的L-白氨酸作為騰泡錠中潤滑劑的兩種配方，探討其間潤滑性、崩解時間和擊碎力的差異。
- When compressed to comparable crushing strengths, the low and high DP cellulose II compacts disintegrated faster in comparison to the corresponding cellulose I compacts. 當壓力達到相同強度時，低、高聚合度纖維素II片比纖維素I片崩解快。
