您要查找的是不是：
- Touch and close fasteners - Determination of longitudinal shear strength. 粘接拉鏈?？v向剪切強度的測定。
- The results show that the shear strength of COF is higher than that of COG. 結果表明 :COF比 COG的剪切強度高 .
- The shear strength of the composite is improved above to 11 MPa from 5.5MPa. 改性后碳 /聚芳基乙炔復合材料的剪切強度由 5 5MPa提高到 11MPa以上
- The shear strength of COG and COF bonded with ACF is studied by impact test. 摘要采用沖擊試驗方法研究了各向異性導電膠膜(ACF)互連的玻璃和柔性基板上倒裝芯片（COG和COF）的剪切結合強度。
- The adhesive should preferably have a shear strength greater than 30 mpa . 粘結膜最好具有大于30毫帕的剪切強度。
- Indirect methods to measure the interface bond strength include the interlaminar shear strength test. 測量界面粘結強度的間接方法包括層間剪切強度試驗。
- Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh. 米勒·普羅森還有基奧都對提高層間切變強度作了大膽的嘗試。
- Variation Rule of Shear Strength Index When Direct Shear Test of Coarse-grained Soil. 粗粒土直接剪切試驗抗剪強度指標變化規律。
- Embedded columns can increase shear strength as well as control of displacement and failure. 配以暗框邊柱能提高剪力墻的抗剪強度、位移控制和破壞控制能力。
- The wood is moderately hard and strong with high bending strength, shear strength and stiffness. 這類木材硬度適中而強壯，具有高度彎曲力、剪力和硬度。
- The melting point and the shear strength of Bi-Pb-Sn-Cd fusible alloys were determined by DSC and tension tester. 利用差熱分析儀和拉伸試驗機;研究了易熔合金Bi-Pb-Sn-Cd的成分對合金熔點和剪切強度的影響.
- Besides, the undrained shear strength was increased slightly due to the negative pore pressure. 不排水條件下由于負孔隙水壓力的存在，土樣的表觀強度略有增大。
- The results showed that the shear strength of epoxy bonded joint decreased after it was aged in acid media. 結果表明，環氧膠接接頭在酸性介質中老化后，其剪切強度明顯降低；
- The results showed that the shear strength of fractal joints decreases nonlinearly as the filling percentage increased. 結果表明，隨著充填度的增大，分形節理抗剪強度總體上呈非線性減小。
- Classical soil mechanics doesn't consider the influence of the matric suction in unsaturated soils on shear strength. 摘要:傳統土壤力學并未考慮不飽和土壤中基質吸力對剪力強度之影響。
- HY/PA can improve not only the transverse shear strength of CF/PA but also the longitudinal shear strength of KF/PA. 另外,HY/PA在改善CF/PA的橫向剪切強度的同時,也改善了芳綸纖維增強尼龍復合材料(KF/PA)的縱向剪切強度;
- The results show that welding parameters do have influence on the microstructure and shear strength of welds. 結果表明，不同的焊接參數對于鋼筋焊接網的剪切性能和組織有不同程度的影響。
- The drilling fluid has high apparent viscosity, high shear strength and strong shear dilution performance. 該鉆井液表觀粘度高，切應力較大，剪切稀釋特性強。
- New soil classification chart and undrained shear strength (cu) based on CPTU are developed in this paper. 提出了新的土分類圖及不排水抗剪強度的估算公式；
- The effects of secondary torsion on shear strength of biaxial flexural reinforced concrete beams are analyzed. 探討了次生扭矩對鋼筋混凝土雙向受彎梁抗剪承載力的影響。
