您要查找的是不是：
- The various types of stress, strain, and elastic modulus are summarized in Table 10-3. 各種應力、應變和彈性模量列于表10-3中。
- The larger the elastic modulus, the greater the stress needed for a given strain. 彈性模量越大，產生一定應變所需要的應力也越大。
- The ratio of stress to strain, or the stress per unit strain, is called an elastic modulus of the material. 應力與應變之比，即每單位應變的應力，叫做該材料的彈性模量。
- Multiple tensions lowed down the elastic modulus of the alloy and exhibited a non-linear relationship with strain. 多次重復拉伸使其彈性模量降低并呈現非線性的變化趨勢。
- An analysis of the complex of viscoelastic country rock compled with viscoelastic (or elastic)lining in a circular drift under plane strain condition is given by this paper. 本文在平面應變條件下,對粘彈性圓形巷道和襯砌的耦合問題進行分析,襯砌(粘彈或彈性的)是在巷道開挖后,或巷道形成后經過一段時間蠕變才加上的。
- With the increase of initial deviator stress, the dynamic elastic modulus increases greatly under the same level of dynamic strain. 在相同的動應變水平下，隨著初始偏移應力的增加，土體動彈性模量有較大幅度的增加；
- The compressive properties of saturated and dry concretes including strength, elastic modulus and peak strain under different loading rates are studied by experiments. 摘要在準靜態及中低加載速率下，開展了飽和與干燥混凝土力學性能變化的試驗研究。
- The two cases of plane stress and plane strain will be discussed separately. 平面應力和平面應變這兩種情況將分開討論。
- The static elastic modulus of the alloy is lower than 30 GPa. 合金的靜態彈性模量小于30GPa;
- The acoustic emissions and elastic strain energy decrease of rock specimens with initially random material imperfections in uniaxial plane strain compression were numerically modeled by using FLAC. 摘要利用拉格朗日元法(FLAC)模擬了單軸平面應變壓縮條件下缺陷數目對含初始隨機材料缺陷巖石試樣聲發射及彈性應變能降低的影響。
- And the polymer is an all-organic composite,with a very high dielectric constant(>900) and high strain induced in a weak applied electric field (2% strain in 13MV/m) and the composite has an elastic modulus near 1GPa. 而全有機復合材料則呈現出十分高的介電系數(>900),和在13MV/m的較低電場下形成的2%25的高應變量及接近1GPa的高彈性模量。
- In this paper, a method by the use of the stress-strain relations and the iterative calculation based on the finite element analysis was proposed to reconstruct the elastic modulus distribution from the axial strain distribution of tissues. 本文提出一種利用組織的應力－應變關系和基于有限元分析的迭代計算方法，從組織的縱向應變分布重建出組織的彈性模量分布。
- There are two plane problems in the theory of elasticity, the problems of plane strain and of plane stress. 彈性理論中有兩類平面問題，即平面應變和平面應力問題。
- This paper introduces the treatment for deep dam foundation of the concrete cut off wall,which intensity and elastic modulus value are requirement to satisfy the stress,strain and durability. 本文介紹了砼防滲墻對土石壩深厚覆蓋層地基的處理,強調防滲墻砼強度及彈模取值應在滿足應力應變的前提下,兼顧耐久性等要求。
- In the case of general anisotropy it is coupled with the ordinary plane strain problem. 在一般各向異性情況下，它與普通手面應變問題綜合在一起了。
- For the joints with low elastic modulus adhesives, both stress concentration degree at the weld spot and the shear strain at edges of overlap region are increased with the spot pitch increasing. 低彈性模量膠粘劑膠焊接頭中，焊點處應力集中程度和搭接區邊緣膠層中的剪應變值都隨焊點間距的增加而增大，增加焊點間距，兩種接頭的膠層斷裂強度都將降低。
- Casing, cement and formation plane strain mechanical model are established, considering casing with initial ovality. 針對套管的不同初始橢圓度建立了套管、水泥環、地層平面應變力學模型。
- The extrusion of compressible material in plane strain is analysed in use of UBET and compared to fully dense material. 應用上限元方法分析了可壓縮材料平面應變擠壓?jiǎn)?wèn)題,并與致密材料進行了比較。
- However, the elastic modulus of SCC is not significantly affected by S/A ratio when total aggregate volume is kept constant. 然而對彈性模數而言，當骨材總體積量一定時，改變混凝土含砂率對于彈性模數并沒有太大的影響。
- The relation of ??to the average value of ??may be assumed to lie between the aforementioned relations for uniform plane stress and uniform plane strain. 而?潞往悶驕?值的關系式可以認為處于上述的均勻平面應力和均勻平面應變的兩個關系式之間。
