您要查找的是不是：
- Insulation thickness for surface temperature. 根據規定的保溫層外表溫度,計算確定的保溫層厚度。
- Determine the "absolute" surface temperature of an object. 確定被測對象表面的“絕對”溫度。
- Check environmental temperature, humidity and coated surface temperature. 測定施工環境的濕度,測定欲涂基面的溫度。
- Estimation of Land Surface Temperature over the Tibetan Plateau Using GMS Data. 用GMS數據估計青藏高原陸地表面溫度。
- Arc Burns. Localized points of surface melting caused by arcing between electrodes or ground and pipe surface. 電弧燒傷。由于電極（含接地極）與管子表面之間起弧而產生的局部表面熔化點。
- Perturbation of ground surface temperature reconstructions by groundwater flow? 用地下水流進行地面溫度重建的擾動?
- Too high of a surface temperature will result in a silicon nitride reaction. 表面溫度過高容易導致硅、氮發生反應。
- Quantitative analyses have been made on the composition of corroded products and the macro-residual stress on the pipe surface by EDX and XRD. 應用 X 射線能譜儀和 X 射線衍射儀分別對腐蝕產物及管表面宏觀殘余應力進行定量分析.
- Contact Mark. Intermittent marks adjacent to the weld line resulting from the electrical contact between the electrodes supplying the welding current and the pipe surface. 觸點痕。由于供焊接電流的電極與管子表面間的電接觸，致使在焊縫線附近產生不連續痕跡。
- Sellars incorporated various empirical relations between ice cover and surface temperature. 塞拉斯處理了冰量和地表溫度的各種經驗關系。
- A nonlinear time series analysis method has been used for reconstruction of sea surface temperature (SST) anomalies. 摘要用非線性時間序列分析方法對海平面溫度距平場進行重構。
- Its companion star,HDE 226868 is a BO super giant with a surface temperature of about 3 1,000 K. 它的伴星HDE226868，質量為超巨大的BO級，表面溫度達到31000開爾文攝氏度。
- Metal separations, resulting from imperfections at the edges of the plate or skelp, parallel to the surface, which turn toward the ID or OD pipe surface when the edges are upset during welding. 由于鋼板或管坯邊緣存在的缺欠所產生的平行于對焊表面的金屬分離，當焊接過程中對焊邊頂鍛時，這些缺欠超者管子內表面或外表面翹曲。
- The size is average, the surface temperature is about 6,000°Celsius, and the color is yellowish. 大小一般，表面溫度約為攝氏6000°，顏色呈淡黃色。
- Using a brush or applicator size no less than 1/2 the pipe diameter, apply a liberal coat of solvent cement to the primed pipe surface, then apply a light to medium coat to the primed fitting socket. 采用一把尺寸不小于管道半徑的刷子或涂敷工具，將足夠量的液狀粘固劑涂敷在上完底漆的管道表面，然后在上完底漆的管件承插部位涂敷較薄或中等厚度的液狀粘固劑涂層。
- When the surface temperature during laser illumination reached 36-45℃, a 30-100 m/sec cryogen spurt was delivered. 利用紅外線溫度檢測回饋系統來控制冷媒噴射出的時間。
- Pipe surfaces must be able to withstand both electrochemical and chemical reactions from the surrounding soil and wastewater conveyed in the pipe. 管子的表面必須能抵抗周?chē)寥篮凸茏又休斔偷奈鬯碾娀瘜W(xué)和化學反應。
- Far-Field Simulation of the Hawaiian Wake: Sea Surface Temperature and Orographic Effects. 夏威夷波的遠場模擬:海表面溫度和地形作用。
- If it is hotter, it is yellow, etc. Thus, we could tell the surface temperature of a star by its color. 因此,我們可以根據恒星的顏色,得知它的表面溫度。
- Epoxy or plastic liming may be cast into the concrete pipe during manufacture;or bitumastic or coal tar epoxy may be painted on the concrete pipe surfaces after installation. 可以在制造混凝土管道時將環氧和塑膠襯里澆筑在里面，或在安裝后用瀝青砂漿或煤焦油屠宰混凝土管的表面。
