您要查找的是不是：
- The diffusion of Ti, C, W of the substrate into the film improved the adhesion strength of the interface. 基體中的元素在薄膜中有明顯的擴散,有助于提高界面結合強度。
- Interfacial adhesion strength of composite is characterized by the methods of torsional braid analysis. 使用扭辮分析對復合材料界面粘合強度進行了表征。
- Rubber adhesive packing tape, gook adhesion strength, water and cold proof. 感壓性牛皮紙膠帶，粘性佳，防水及耐候性?xún)?yōu)良，主要用于紙箱包裝。
- The "Scotch tape test" was designed to measure the adhesion strength of the metal coating to the PET fabric. 采用自主設計的“透明膠帶法”測量金屬與織物纖維的結合力。
- Pyrogenic silica, configuration controller and silane coupling agent influence the adhesion strength to some extent. 氣相白炭黑、結構控制劑和硅烷偶聯劑對粘接抗拉強度都有不同程度的貢獻。
- Higher adhesion strength was achieved by adding the treated additive LW with CTAB and silane coupling agent KH550. 當采用硅烷偶聯劑KH550、十六烷基溴化胺對LW表面進行處理;粘合性能可以進一步提高;并且硅烷偶聯劑KH550處理LW的效果更好.
- SEM photos reveals the combination of ATPU and OMMT enhances the interphase adhesion strength between polymer matrix and glass fiber. 丙烯酸酯封端聚氨酯與改性蒙脫土的復合還提高了聚合物基體與玻璃纖維的界面粘合強度。
- Studies indicated that cohesion increased with the increase of crosslinking agent from 0.2% to 1.2%, but adhesion strength and tack decreased. 研究表明;隨著交聯劑用量從0.;2%25增大至1
- A series of Aluminium silicate gunning refractories and its properties, such as thermal shock resistance, adhesion strength, were measured. 配制系列硅酸鋁質噴補料并檢測其抗熱震性及噴補附著性能等。
- The results show that the adhesion strength of UHSPE fiber/epoxy resin can be greatly improved via corona discharge su... 結果表明,經電暈法表面處理后的UHSPE纖維單絲與環氧樹脂的界面粘結強度有了很大的提高。
- T. Arai , H. Fujita , M. Watanabe, “Evaluation of adhesion strength of thin hard coatings”, Thin Solid Films, 154 (1987) 391. 吳明勛，“添加銀或鎢對氮化鉻薄膜磨潤性能之影響”,國立成功大學機械工程學系，中華民國92年。
- Polish film surface smoothness and adhesion strength setting time of General with more, but more and more slow speed of up to a certain value, grew. 上光膜層的表面平滑度和粘附強度一般隨固化時間的增加而提高，但提高的速度愈來愈慢，達到一定數值后就不再增大。
- In it's raw state, LS has very little adhesive strength. 在它的原始狀態，液體軟陶有一定的粘結強度。
- A fundamental study was carried out on the microstruc-ture, surface hardness and adhesion strength of DS NiCrAlTaY coating by means of XRD, SEM and EDS. 借助XRD;SEM和EDS等技術對涂層的組織結構、表面硬度與粘結強度進行分析.
- The results show that the adhesion strength is low and the adhesion bonded aluminum sheet/polypropylene/aluminum sheet fractures at the interface when there is no MPP in PP. 研究結果表明： 當PP中不含MPP時， 界面粘接強度低， 拉伸剪切時表現為鋁板/聚丙烯粘接界面的破壞；
- The results show that the in-terfacial adhesion strength increased noticeably for composites of active aramid fiber but the fracture energy of the interface decreased. 實驗結果證明,芳綸表面改性顯著提高了其復合材料界面的粘結強度,相反卻降低了其界面斷裂能。
- The effects of the content of foaming agent as well as the kinds and content of foam stable agent on the foamability and the adhesion strength were investigated. 考慮了發泡劑用量、泡沫穩定劑種類及用量對發泡倍率和粘接強度的影響。
- When the polyester cord is dipped with RFL,a good adhesion of rubber to the cord can be obtained.If the chlorophenolic resin is added,the adhesion strength will improve further. 聚酯線繩通過由間苯二酚、甲醛及膠乳所組成的水乳液浸漬后．可使其與橡膠間具有優異的和穩定的粘合性能，若加人氯化酚醛樹脂，則可使粘合強度得到提高。
- A white lead pigment, sometimes used in cosmetics. 鉛白一種白色鉛顏料，有時用于化妝品制造
- The influence of filler on extensibility, elasticity and adhesion strength of film, and influence of environment temperature on coated film surface dry time are studied. 研究了填料對膜延伸性、彈性、粘結強度的影響，環境溫度對涂膜表干時間的影響。
