您要查找的是不是：
- Inspecting the oil level of motor lubrication. 檢查發動機潤滑油油面。
- Check the engine oil level regularly. 要時常檢查機油量。
- Inspect the hydraulic oil level of clutch. 檢查離合器液壓油油面。
- Add 2.0 litre5 to reach max．oil level! 添加2升以達到液位上限!
- If equipped with an oil level sensor, disconnect the sensor. 如果配備有油面感知器，斷開感知器。
- Methods: to keep the crankshaft inside a normal oil level. 方法：保持曲軸箱內正常的機油水平。
- Sealed oil chamber does not require constant monitoring of oil level. 密封的油箱,不需要經常觀察油量的多少。
- Through the oil level indicator, we check the hydraulic oil level of crane. 利用油位指示器檢查起重機的液壓油位。
- It is important not to exceed the recommended oil level if leakage is to be avoided (table). 如果要避免漏油,不能超過建議的油量,這是很重要的,見表13。
- Oil level marks in the housing and an oil level gauge help to keep the correct oil level. 軸承座內的油位標記和油位表使油位保持在正確水平。
- Examine working status of the frame, degree of cleanness and oil level of lubricating oil termly. 定期檢查托架的使用情況，定期檢查潤滑油的清潔度和油位。
- Fill oil pan 1 with JUKI Machine Oil No. 7 up to HIGH mark A.When the oil level lowers below LOW mark B, refill the oil pan with the specified oil. 請把JUKI Machine Oil No.;1機油倒進油槽1里，一直加到HIGH標記A的位置。油槽的油面降到LOW標記B以下時，請再次補充機油。
- In this paper, fiber-reinforced epoxy foam composite used as floater for indicating height of oil level in automobile braking system was investigated. 研究了纖維增強環氧發泡材料用于轎車剎車油液面指示用浮子。
- Tip: If you don't know the oil capacity of the engine, add four quarts, then check the oil level, if it's a quart low add another quart. 冰山:如果你不知道發動機油容量;加上四個石英;然后檢查石油級如果是低再添一石英石英.
- While simulating high oil temperature and high oil level failure conditions, the corresponding indicating lamp should light up and failure pre-warning messages should be sent out. 模擬油溫高、油位高故障,相應的指示燈亮且應有故障預報警信號輸出。
- A seal kit consists of two labyrinth seals and is supplied together with an oil pick-up ring, an oil level gauge, a magnetic plug and mounting instructions. 密封套件包含兩個迷宮密封件,在提供給用戶時還帶有一個拋油環、一個油位表、一個磁鐵油塞,以及安裝說明。
- Oil of reducer should be replaced every half year.The oil storage of reducer must be kept on prescribe oil level during operation and should not be too much. 走行減速機要定期更換潤滑油。每半年更換一次。運轉中，減速機體內儲油量必須保持規定油位，不宜過多或過少。
- Flammable gas found in the relay indicates some internal fault such as overheating or arcing, whereas air found in the relay may only indicate low oil level or a leak. 而繼電器內的空氣只說明油位低或者有漏油。
- The frame is equipped with an oil dipstick, the oil level should retain in the middle position.Generally, lubricants are the mechanical oil 20#, 30# or 40#. 托架上配有油標，油位應始終保持在油標的中間位置，潤滑油一般為20%23、30%23、或40%23機械油。
- Measure the oil level by momentarily inserting the dipstick fully into the dipstick tube and removing.Record the distance between the tip of the dipstick and the oil line. 通過機油尺管插入機油標尺來測量機油液面并擦拭干凈，記錄機油尺前端到油線的距離。
