您要查找的是不是：
- When it accumulated to a higher degree, the specimen began to shear and dilate after a short time of strain hardening. 達到一定程度后，巖石表現出短暫的應變硬化，巖石開始剪脹。
- The geometric and material nonlinearities,the linear kinematic hardening and the effect of strain hardening at corner zone by cold-forming are taken into account in the model. 分析結果表明:寬厚比和軸壓比對構件滯回性能影響顯著,隨著寬厚比的增加,構件承載、轉動以及塑性變形能力降低;
- Nonlinear modulus of rock is function of strain level and strain amplitude.The modulus decays exponentially with ascending of strain amplitude, while increases with strain level increasing. 巖石非線性模量既是所受應變水平的函數，也是應變振幅的函數，模量隨應變振幅的增加以指數形式下降，隨應變水平增加以指數形式上升。
- The percussion figure of biotite as the product of brittle deformation occurs within the mylonite belt characterized by ductile deformation because of strain hardening during tectonic pulsation. 黑云母擊象是脆性變形產物,它形成于以柔性變形為主的糜棱巖帶中是由于構造過程中的應變硬化。
- Within the region of lower load,the moduli of the carbon fibersincrease with the increase of strain. 各向同性瀝青基碳纖維的模量則隨應變的增加而有所下降。
- She's under a lot of strain at the moment; her child's very ill. 她現在心情緊張，因為她的小孩病得很厲害。
- Modulus of elasticity for tension? 拉伸彈性模量?
- Modulus of elasticity of volume? 體積彈性模量?
- RESEARCHES ON THE CALCULATION METHOD OF STRAIN HARDENING OF COLD-FORMED STEEL 冷成型鋼冷作強化計算方法探討
- I've been under a lot of strain. 我現在壓力好大。
- The static elastic modulus of the alloy is lower than 30 GPa. 合金的靜態彈性模量小于30GPa;
- COMPARING THE RESULTs OF STRAIN HARDENING EXPONENT, PLASTIC STRAIN RATIO VALUE AND ELONGATION BY TWO DIFFERENT METHODS 兩種方法測定冷軋薄板應變硬化指數、塑性應變比值和伸長率的結果比較
- The signs of strain were on both women. 這兩個女人身上仍殘留著過度勞神的痕跡。
- The Influences of Models Material and Law of Strain Hardening to Drawing Forces and Precision of Tube 材料模型和強化規律對空拔管拔制力和尺寸精度的影響
- To stretch one's body or muscles to the point of strain or injury. 過度伸展伸展身體或肌肉到了扭傷或損傷的程度。
- The ratio of stress to strain, or the stress per unit strain, is called an elastic modulus of the material. 應力與應變之比，即每單位應變的應力，叫做該材料的彈性模量。
- Multiple tensions lowed down the elastic modulus of the alloy and exhibited a non-linear relationship with strain. 多次重復拉伸使其彈性模量降低并呈現非線性的變化趨勢。
- rate of strain hardening 應變硬化速率
- The strain hardening behaviour of five TWIP steels with different Mn content was investigated by static tensile test and metallography. 采用靜態拉伸、金相組織觀察方法研究了5種不同錳含量的TWIP鋼的拉伸應變硬化行為。
- These two parameters are nowadays called the modulus of compressibility. 這兩種參數現被稱為壓縮模量。
