您要查找的是不是：
- The estimation of median tolerance limit of polynuclear aromatic hydrocarbons by gas chromatography 氣相色譜法估算多環芳烴半數致死濃度
- median tolerance limit 半耐極限
- Stricter acceptable tolerance limit values for customers/sales. 加嚴的顧客/銷售接受容差限值。
- The compaction force of the prepared punch exceeds the tolerance limit plus. 標記沖桿壓力正偏差超過允許范圍。
- The compaction force of the prepared punch is lying outside the tolerance limit plus. 標記沖桿壓力在正偏差之外。
- Ensure with each setting that the compaction force of the prepared punch exceeds the tolerance limit plus. 確保每個標記的壓片沖桿的壓力設定超過壓力正偏差。
- Pay attention that the main pressure set value does not exceed the tolerance limit plus. 注意主壓力設定值不能超過正公差。
- Pay attention that the main pressure set value does not fall below the tolerance limit plus. 注意主壓力設定值不能低于正公差范圍。
- Objective To study the tolerance limit of crewman's arms to windblast with and without protective devices. 摘要目的研究人上肢有／無防護時耐受高速氣流吹襲限值；
- Objective To study the tolerance limit of crewman s arms to windblast with and without protective devices. 目的研究人上肢有／無防護時耐受高速氣流吹襲限值；為防護裝置的設計要求提供試驗依據。
- The tablet press is running in set up mode and the compaction force of the prepared punch is still lying outside the tolerance limit plus. 片劑按設定模式運行,標記沖桿壓力在正公差之外。
- Start the tablet press and ensure that the compaction force of the prepared punch still exceeds the tolerance limit plus. 啟動壓片,確保標記沖桿壓力在正公差之外。
- In the meantime, the tolerance limit of coordinate difference in the station for site testing is given and it is possible to test total station coordinate trave rse in site. 同時，根據該原理，給出了測站坐標差限值，從而實現了全站儀坐標導線的現場檢核。
- The compaction forces of the other punches are within the tolerance limits. 其他沖桿壓力在偏差范圍內。
- It wants to anchor inflationary expectations after the painful experience of the past year, when inflation stayed well above the tolerance limit of 5 percent. 經過了去年的痛苦經歷，在通貨膨脹的水準遠高于容忍限度5%25的時候，它想讓通貨膨脹的預期拋錨。
- Adjust the tolerance limits of the main pressure in such a way that the pressure of the prepared punch lies within the tolerance limits. 調整主壓力的允許范圍,這時準備好的沖桿壓力應在允許范圍內。
- This test checks whether the monitoring of the compaction force works in case of an infringement of the tolerance limits. 這個測試是檢測假設監控壓力超過公差范圍是否起作用。
- "Are there tools and procedures with tolerance limits in place for front-to-back registration verification during the artwork setup? Is it identified as a critical SPC parameter? 在底片設計階段，是否確認了前后對準度的工具/制程最大公差？是否被定義為關鍵SPC參數？"
- Surely there is a limit to what one can bear. 人的忍耐肯定是有限度的。
- The proposal set a time limit of one year. 提案規定了一年的限期。
