您要查找的是不是：
- What is Pulse Amplitude Modulation? 什么是脈沖調幅?
- The results demonstrate that with the increment of applied pulse amplitude and pulse width, the maximum length and the number of origin points of the streamer increase. 研究結果表明，水中放電的最大流注長度和通道起始點數均隨脈沖電壓幅值和脈沖寬度增加而增加。
- Trigger control circuit from complex programmable logic device (CPLD), ICL7135CN, the clock pulse circuit and optocoupler inverter constituted. 觸發控制電路由復雜可編程邏輯器件（CPLD）,ICL7135CN,時鐘脈沖電路、反相器和光耦構成。
- The modulator was used as both a mode locker and a pulse amplitude equalizer in the cavity. 用時域分析的方法證明這種結構在調制器工作在其特性曲線的線性區時可以實現 5階以下有理數諧波鎖模的脈沖幅度均衡。
- Experimental Study on Pulse Amplitude Stablization in a Q-Switched Single Longitudinal Mode Nd:YLF Laser[J]. 引用該論文 郭小東;陳紹和;王世績;顧援;鄧錫銘.
- By careful selection of the ratio between this resistor and the integrating resistor (a few tens of ohms in the recommended circuit), the comparator delay can be compensated and the maximum clock frequency extended by approximately a factor of 3.3. 通過小心選擇這個電阻和積分電阻之間的比值（在推薦線路里，大約是數十歐姆），比較器的延遲就可能被補償，最大的時鐘頻率可近似延伸到3.;3倍。
- Objective To define the ranges of IOP and ocular pulse amplitude(OPA)using Dynamic Contour Tonometer(DCT)in a healthy Chinese population. 目的調查動態輪廓眼壓計(Dynamic Contour Tonometer,DCT)眼壓及眼脈動幅度(Ocular Pulse Amplitude,OPA)在健康人群中使用時測量值范圍。
- The generator is mainly used for the accurate measurement of the channelwidth uniform of a multichannel pulse amplitude analyzer. 主要用于多道脈沖幅度分析器的道寬一致性的精確測量.
- Simulation results show that the phase-shift between pumping and signal light in PSA results in descending of soliton pulse amplitude. 仿真結果表明：抽運光與信號光之間的相位漂移將導致孤子脈沖幅度下降。
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the last clock pulse, the keyboard/mouse does not need to retransmit any data. 如果在第一個高->低時鐘跳變時，（或者在最后一個時鐘脈沖的下降沿之后）主機將時鐘拉低，鍵盤/鼠標不必重新傳輸任何數據。
- The error of measurement caused by measuring pulse amplitude with oscilloscope is analized.And the reason of the overproof and the unususal phanomenon are analized also. 分析了用數字示波器測量脈沖幅度帶來的測量誤差，以及測量中產生超差現象和異?，F象的原因。
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the last clock pulse, the keyboard/ mouse does not need to retransmit any data. 如果在第一個高->時鐘跳變時，（者在最后一個時鐘脈沖的下降沿之后）機將時鐘拉低，鍵盤/標不必重新傳輸任何數據。
- Change the inverter output voltage or output current are two kinds of different ways, namely, PAM pulse amplitude modulation control and PWM control pulse width modulation. 改變變頻器的輸出電壓或輸出電流有二種不同的方法，即PAM脈沖幅值調制控制和PWM脈沖寬度調制控。
- If the host pulls clock low before the first high-to-low clock transition, or after the falling edge of the a last clock pulse, the keyboard/mouse does not need to retransmit any data. 如果在第一個高->低時鐘跳變時，（或者在最后一個時鐘脈沖的下降沿之后）主機將時鐘拉低，鍵盤/鼠標不必重新傳輸任何數據。
- DC-voltage comparative method and high sampling digital multimeter method can measure the pulse amplitude accurately,but their application is relatively limited. 直流電壓比較法和高采樣數表法可對脈沖幅度進行準確測量,但僅適于周期低頻信號,應用受到局限。
- The parallel loading of the flip-flop can be synchronous (i.e., occurs with the clock pulse) or asynchronous (independent of the clock pulse) depending on the design of the shift register. 觸發器的并行加載可以是同步的（即在時鐘脈沖到達時發生）或異步的（不依賴于時鐘），這取決于移位寄存器的設計。
- Abstract: The error of measurement caused by measuring pulse amplitude with oscilloscope is analized.And the reason of the overproof and the unususal phanomenon are analized also. 文摘:分析了用數字示波器測量脈沖幅度帶來的測量誤差，以及測量中產生超差現象和異?，F象的原因。
- A microprocessor designer may decide to make all instructions last five clock pulses. 微處理機設計人員可以決定使所有的指令持續五個時鐘脈沖。
- Note that a set of lights attached to O1, O2, O3 would display the numbers of full clock pulses which had been completed, in binary (modulo 8), from the first pulse. 注意，一組接在O1,O2,O3上的燈泡將以二進制（模8）形式顯示第一個脈沖以來已完成的完整時鐘脈沖數。
- In binary synchronous communication, the use of clock pulses to control synchron ization of data and control characters. 在二進制位同步通信中,使用時鐘脈沖來控制數據和控制字符的同步。
