您要查找的是不是：
- maximum allowable pressure drop 最大容許壓力降
- The relative factors are discussed:maximum allowable pressure inside the site, permeating coefficient of of MSW,bio-gas production rate, diameter of the well, etc. 同時討論了影響控制范圍的各主要因素：垃圾層中最大允許壓力、垃圾層的透氣性能、垃圾的產氣速率等。
- Requested add of item exceeds maximum allowed. 請求添加的項目超過允許的最大數目。
- The relative maximum allowed value. 允許的相對最大值。
- Maximum allowed size for uploaded files. 最大允許上傳文件尺寸;
- Watch pressure drop on pressure gauge. 手表壓力在壓力標準度量上降低。
- The absolute maximum allowed value. 允許的絕對最大值。
- Valve exhibits high pressure drop. 閥門出現高壓降。
- The maximum allowed binary length of a. 對象的最大允許二進制長度。
- The maximum allowed size is XX bytes. 允許裝入的最大尺寸為 XX 字節。
- Criteria for selection is minimum flow, normal flow, maximum flow and pressure drop across the valve. 選型標準是最小流量，正常流量，最大流量和通過閥門的壓降。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 壓力是否降至0PSI而且條件"NO DRIVE"出現?
- However, the pressure drop occurs almost completely in the plug. 然而，壓力降幾乎完全發生在多孔塞中。
- Gets or sets a value indicating the maximum allowed memory size. 獲取或設置一個值,該值指示所允許的最大內存大小。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作應用。
- Gets or sets the maximum allowed length of an error response. 獲取或設置錯誤響應允許的最大長度。
- Gets or sets the maximum allowed length of the response headers. 獲取或設置響應標題允許的最大長度。
- Presents the theoretical model of pressure drop for flexible duct. 摘要介紹了柔性風管壓力損失的理論模型。
- Shut down because of the maximum allowed idle time limit. 由于允許的最大空閑時間限制而關閉。
- They are commonly used where a minimum pressure drop is important. 通常用在要求壓降最小的應用場合。
