您要查找的是不是：
- Low density polyethylene(LDPE) modified asphalt dispersed finelyin asphalt is prepared by two-step blending process. 采用二階共混法制備了能在瀝青中微細分散的LDPE改性瀝青。
- Constructed of low density polyethylene (LDPE): a durable, lightweight and FDA food grade approved material. 修建低密度聚乙烯(LDPE)：耐久，輕量級選手和糧食與藥物管理局食品等級批準了材料。
- The rheological behavior was studied for blends of metallocene catalyzed ethylene/1-butene copolymer(mPE) and low density polyethylene(LDPE). 研究了茂金屬催化乙烯 丁烯 1共聚物mPE和LDPE共混物的流變行為 .
- It is used for blowing various plastic film of low density polyethylene(LDPE),high density polyene(HDPE)and linear low density polyethylene(LLDPE)etc. 用于吹制高低壓聚乙烯,產品廣泛用于復合膜,包裝膜,農業復蓋臘，紡織品，服裝袋或膜等包裝；
- Biaxial self-reinforced metallocene linear low density polyethylene sheet was prepared by the die with complex stress field in solid state. 主要采用一種具有復合應力場的擠出口模,通過固態擠出茂金屬線性低密度聚乙烯獲得雙向自增強片材。
- This paper altered one plastics character by physically blending in other plastic while keeping low density polyethylene as a basic part. 文章以目前導爆管的管壁材料低密度聚乙烯塑料為主體,對塑料原料進行物理共混改性。
- White LDPE Scrap (loose) , White LDPE Scrap (loose) shall consist of sorted white Low Density Polyethylene (LDPE) scrap. 白色LDPE小塊(散裝)將包括被分類的白色低密度聚乙烯(LDPE)小塊。
- Furthermore, the inner layer is made low density polyethylene which can remove the static can avoid static generation inside the bag. 另外里面一層是由可消除靜電乙烯組成，可以防止在袋內產生靜電。
- Results of measurements of the electrical conductivity of low density polyethylene (polystyrene)polypyrrole composites are reported. 介紹了低密度聚乙烯（聚苯乙烯）／聚吡咯復合材料的導電特性。
- The fisheye problems appeared in the post processing of linear low density polyethylene(LLDPE) blown film were discussed. 探討了吹膜后期加工過程中出現的晶點問題,指出在催化劑制備過程中,應當嚴格控制反應物中的雜質含量;
- Reproducibility of electrical conductivity of low density polyethylene (LDPE)/carbon black (CB) during the heating/cooling recycling was studied. 研究了低密度聚乙烯(LDPE)/炭黑(CB)復合物在升溫、降溫循環中的導電性能。
- The graft copolymerization of acrylic acid (AA) onto low density polyethylene(LDPE) with benzoyle peroxide (BPO) as initiator in anhydrous xylene was studied. 在二甲苯溶液中以過氧化苯甲酰為引發劑研究了丙烯酸在聚乙烯上的接枝共聚。
- The grafting of acrylic acid on to low density polyethylene(LDPE) was studied in solution. Benzoyl peroxide(BPO) and xylene were used as initiator and solvent respectively. 以過氧化苯甲酰（BPO）為引發劑，二甲苯為溶劑，進行了丙烯酸與低密度聚乙烯（LDPE）的溶液接枝聚合。
- The melt grafting of maleic anhydride (MAH) onto linear low density polyethylene(LLDPE) was initiated by dicumyl peroxide(DCP) in a twin screw extruder. 以過氧化二異丙苯(DCP)為引發劑,在雙螺桿擠出機中進行了馬來酸酐(MAH)熔融接枝線性低密度聚乙烯(LLDPE)的研究,用紅外光譜表征了接枝反應的存在。
- It is used f o r blowing the various plastic film of low density polyethylene(LDPE), high density polyethylene(HDPE) a n d linear low density polyethylene(LLDPE) etc. 用于吹制各種低密度聚乙烯(LDPE)、高密度聚乙烯(HDPE)和線性低密度聚乙烯（LLDPE）等塑料薄膜。
- The extrudate swell behaviour of linear low density polyethylene and low density polyethylene blend (LLDPE/LDPE) melt is studied by means of a capillary rheometer. 應用毛細管流變儀,考察了實驗條件下線性低密度聚乙烯與低密度聚乙烯共混物(LLD-PE/LDPE)熔體擠出脹大行為及其影響因素。
- In this study,the blends of methylvinylsilicon rubber(VMQ) and linear low density polyethylene(LLDPE) thermoplastic elastomer have been prepared by dynamical vulcanization. 采用動態硫化法制備了甲基乙烯基硅橡膠(VMQ)/線形低密度聚乙烯(LLDPE)熱塑性彈性體。
- Colored LDPE Regrind, Colored LDPE Regrind shall consist of shall consist of sorted reground flake of Low Density Polyethylene (LDPE), sorted into a single color. 有顏色的LDPE再生（料）將包括將包括低密度聚乙烯被分類的被再生（料）(LDPE),被排序入一種唯一顏色。
- The rheological properties of low density polyethylene (LDPE) were measured under conditions close to the practical extrusion process by means of a capillary rheometer. 應用毛細管流變儀測量了在接近實際擠出工藝條件下低密度聚乙烯熔體的流變性質;
- It is used for blowing the various plastic film of low density polyethylene(LDPE), high density polyethylene(HDPE) and linear low density polyethylene(LLDPE) etc. 詳細內容：用于吹制各種低密度聚乙烯(LDPE)、高密度聚乙烯(HDPE)和線性低密度聚乙烯（LLDPE）等塑料薄膜。
