您要查找的是不是：
- Very low residue and few causticity ,with high-surface insulation resistance value , no need to wash it also can reach the excellent ICT test value . 焊接后殘留物少，腐蝕性小，具有極高的表面絕緣阻抗值，無需清洗即可達到極佳的ICT測試性能。
- Measure winding insulation resistance, use 500v Megohmmeter, insulation resistance value shall not less than 0.5 under normal temperature. 測量繞組的絕緣電阻;使用500V兆歐表;常溫下絕緣電阻值不應低于0.;5;
- INSTANT OVERLOAD CAPABILITY; WITHOUT ANNUAL SHIFT ON RESISTANCE VALUE. 耐短時間過負載,阻值長時間變化。
- High fracture toughness and insulation resistance. 高斷裂強度及絕緣性能。
- This will determine the maximum allowable resistance value of the DB resistor. 這將決定制動電阻最大允許值。
- Measuring insulation resistance for circuit. 電路絕緣電阻測量。
- To measure the hot insulation resistance. 熱態絕緣測量。
- The insulation resistance is too low. 絕緣電阻太低。
- High break down voltage and insulation resistance. 高耐壓及絕緣性能。
- And shake the electrical insulation resistance measurement, and its value is not lower than 50 megohm. 然后搖測電機的絕緣電阻，其值不低與50兆歐。
- Variance coefficients of BYDV resistance value reduces rapidly when generation added, and BYDV resistance gene purify rapidly. 抗性變異隨世代的增加減幅較大，抗病基因純合較快；
- Shall we start the testing of cold insulation resistance? 冷態絕緣電阻測試是否可以開始?
- Test and mark the resistance value of the old elements having been replaced (with voltmeter and ammeter) and distribute them in low temperature area. 換下來的元件重新（用壓表、電流表）測標其電阻值，配阻用在低溫區。
- The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly. 然后儀表通過同一套測試引線來測量電阻兩端的電壓，并計算出相應的電阻數值。
- If the insulation resistance is under the numerical value required or the tie-in of the cable loosen or break off,the result will be noted. 如有絕緣電阻低于絕緣要求，或電纜接頭松脫、斷線，結果將被自動記錄。
- The D.C. resistance of each phase is also checked against the calculated resistance value for the stator and for balanced resistance between each phase. 每個相位的直流電阻也經過與定子的設計負載電阻值進行核對,以確認能夠在每個相位之間進行平衡。
- Pump before use application megohm table to check the electrical insulation resistance the minimum value of not less than 5 megohm. 電泵在使用前，應用兆歐表檢查電機絕緣電阻，其最低值不能小于5兆歐。
- Select resistance values for R1 and R2 such that 20 mA flows through each LED. 為R1和R2選擇合適的阻值，使得通過每一個二極體的電流都為20毫安培培。
- Among it the sensing surface of sensor should be established Whetstone Bridge, when the pressure is increased, resistance value of each bridge arm takes place change. 其中傳感器感壓面有惠斯頓電橋,當增加壓力時,電橋各橋臂電阻值發生變化。
- The temperature characteristics of insulation resistance of capacitor covers. 電容器蓋板絕緣電阻的溫度特性。
