您要查找的是不是：
- To evolve a simulation program, it is usually most convenient to draw up a flow chart. 搞一個模擬程序，通常最好是先畫出一個流程圖。
- Generation production costs and their present worth may be computed using a production simulation program. 發電的生產成本和目前的產值可用生產模擬程序計算。
- The simulation program is written with C++ language based on platform mode and debugged with Watcom C++. 仿真程序用C ++語言編寫 ,在Windows 98環境下用WatcomC ++環境進行調試。
- BPSK This is a simulation program that can be given Channel SNR calculation BPSK system error probability. 這是一個BPSK仿真程序，可以在給定信道信噪比下計算BPSK系統的差錯概率。
- Simulation program was compiled,and it was applyed to typical following condition and cut-in condition . 編制了模擬仿真程序,并應用程序對典型的跟隨工況和切入工況進行了模擬仿真。
- A simulation program,which includes 4 subprograms inside its unit calculation module,is developed. 程序由4個主要模塊組成。
- The simulation program is made in order to compare capability of the joint direct attack munition(JDAM) when the upgrade kits are added. 通過六自由度彈道仿真,比較了增加組件前后聯合制導攻擊武器的性能指標。
- TOXI model is a part of WASP(Water Quality Anaiysis Simulation Program )ftom the United Sates Environmental Protection Agency. TOXI模型是美國環保局的WASP（水質分析模擬程序）中的一部分。
- So the Curtice modeland the Statz model in SPICE or PSPICE circuit simulation program is most widely used forGaAs IC design. 因此在電路模擬程序SPICE或PSPICE中通常采用Curtice模型和Statz模型。
- The simulation program is made in order to compare capability of the joint direct attack munition (JDAM) when the upgrade kits are added. 通過六自由度彈道仿真，比較了增加組件前后聯合制導攻擊武器的性能指標。
- The techniques to advance the penetration probalility of TBM are given according to this model by using computer simulation program. 通過仿真計算分析,提出了提高彈道突防能力的技術。
- In this study, a common used DSMC simulation program has been adopted and developed for studying general two- and three-dimensional rarefied gas flows. 關于直接模擬蒙地卡羅法，其主要的關鍵是：在一個足夠小的時間步前提下，分子本來耦合在一起的運動與碰撞行為，得以分開處理；
- PECS(Power Electronic Circuits Simulation) is a kind of simulation program,which is a branch of CAD (Computer Aided Design). PECS（Power Electronic Circuits Simulation）是一種電力電子電路仿真軟件，是電路CAD（Computer Aided Design）的一個分枝。
- At the following chapter, the fixed point ANSC C simulation programs G. 在對該協議進行了深刻探討的基礎上，運用開發工具VC++6.;0對G
- The simulation program utilizing multithread technique realizes the realtime estimation and reduces the reaction time of the system. 仿真程序采用多線程技術，實現了實時測量，縮短了系統反應時間。
- Parallel discrete event simulation (PDES) refers to the execution of single discrete event simulation program on a parallel computer. 并行離散事件仿真PDES（Parallel Discrete Event Simulation）是指在并行平臺上執行離散仿真應用程序。
- Taking OTC as an example, the present article discusses the application of simulation technology to mechanical dynamic system. A simulation program DSCS is compiled. 本文以橋式起重機為例,探討了計算機仿真試驗技術在機械動力學研究中的應用,并編制了仿真試驗程序DSCS。
- J. Srebric, Chen, Q, L. R. Glicksman,“A Couple Airflow and Energy Simulation Program for Indoor Thermal Environmental Studies,” ASHRAR Transactions, Vol.106, Pt.1, 2000. 謝明峰，空調低溫送風不結露擴散器之設計研究，碩士論文，國立臺北科技大學電機與能源研究所，臺北，1999。
- This thesis employs a power system simulation program, CYME, to analyze dynamic and steady-state performance of dispersed generation systems connecting to an utility grid. 文中利用電力系統之模擬軟體CYME來分析分散式發電系統與市電系統并聯運轉時，可能發生動態與穩態特性影響。
- The simulation program is written in C language not only to verify the accuracy the analytical results but also to understand and control the details of various CAC schemes. 電腦模擬程式是以C語言自行撰寫，以驗證解析結果之準確度，以及瞭解及控制各種連結允入控制方法之細節。
