您要查找的是不是：
- A hot dip Zn 5%Al RE coating on high carbon steel wire is tested. 試驗了在高碳鋼絲表面上熱浸鍍Zn 5%25Al RE合金層。
- The Annealing Furnace is a key Equipment for any Hot Dip Galvanizing Line. 對于任何連續熱鍍鋅線退火爐都是關鍵設備。
- The hot dipping alumetizing technology for 20G seamless steel tube was studied. 摘要對20G無縫鋼管的熱浸滲鋁工藝進行了研究和試驗。
- High structure strengh,hot dip galvanized,greatly protract time of use. 高強度管材、產品經熱鍍鋅處理、大大地延長了使用壽命；
- Structure: Adopting to polyester film as dielectric, iuductrive construction, epoxy resin as dip material. 結構:聚酯膜作介質,有感結構,環氧樹脂包封。
- Surface quality of hot dip plating Zn-Al alloy were further improved. 采用該合金助鍍劑進行Zn Al合金熱浸鍍的樣品 ,表面質量得到進一步改善。
- By metalloscope, SEM and spectrometer, the basic technical parameters of hot dipping alumetizing were obtained. 在對滲鋁鋼管進行金相、SEM和能譜分析后，確定了熱浸滲鋁的基本工藝參數。
- The cold rolled coils entered into hot dip galvanizing workshop are put on waiting position and then transferred to uncoiler by coil car. 冷軋卷進入熱鍍鋅車間后置于待處理位置,然后通過上卷小車送至開卷機。
- Commodity:Hot dipped galvanized steel in coil . 貨物名稱:冷軋熱鍍鋅卷。
- The effects of aluminum bath temperature, immersion time and silicon content on hot dip aluminum for HT200 are studied. 研究了熱浸溫度、時間及硅含量對HT200熱浸滲鋁的影響。
- Technologies were then developed including using of zinc alloy, such as Zn-Mn, Zn-Mg and Zn-Ni alloy baths, and high temperature hot dipping process. 為此，國外發展了多種熱鍍鋅技術，包括在鋅浴中添加合金元素的多元合金、鋅錳合金、鋅鎂合金和鋅鎳合金熱鍍鋅技術及高溫鍍鋅技術。
- Abstract: The new Technology of soluble anode electrolysing hot dipping zinc slag is analyzed. 文摘:從理論上分析了可溶陽極電解處理熱鍍鋅廢渣新工藝的可行性。
- Wear resistance of Q195 after Al hot dipping and post diffusion was studied and compared with that of carbonized Q195. 對Q195普通低碳鋼分別進行熱浸鍍鋁加共滲處理和滲碳處理,并對兩種處理件進行耐磨性試驗。
- Abstract: The hot dipping alumetizing technology for 20G seamless steel tube was studied. 文摘:對20G無縫鋼管的熱浸滲鋁工藝進行了研究和試驗。
- The new Technology of soluble anode electrolysing hot dipping zinc slag is analyzed. 從理論上分析了可溶陽極電解處理熱鍍鋅廢渣新工藝的可行性。
- The research status of hot dipping galvanizing for evaporative condenser coil and its mechanism were reviewed. 綜述了蒸發式冷凝器盤管熱浸鍍鋅機理及熱浸鍍鋅的研究現狀。
- The application technology of powder coatings for hot dipping galv an ized guardrail of highway is introduced. 介紹了熱浸鋅高速公路護欄噴塑涂裝工藝方法,在工藝生產中應該注意的問題和解決方法。
- The technique of hot dip Zn-Ni alloy coating is an effective method for solving the reactive steel problem in hot dip galvanizing. 熱浸鋅鎳合金鍍層技術是解決活性鋼熱鍍鋅問題的有效方法。
- Effects of cooling rate on eutectic microstructure of Zn-(0.24Ni) alloy for hot dip galvanization were investigated. 研究了冷卻速度對用于熱浸鍍Zn的Zn0.;24Ni合金共晶組織的影響。
- The effect of Ni content in Zn bath on thickness of hot dip galvanized coating was studied using SEM. 應用SEM、EPMA等方法研究了鋅浴中鎳含量對熱浸鋅鍍層厚度的影響，試驗結果表明：當鋅浴中鎳含量小于0.;12%25 (wt)時，鍍層隨鎳含量增加而減??；
