您要查找的是不是：
- Here, cooling time is defined as holding time. 在這里，冷卻時間定義為保壓時間。
- A variable displacement pump could save energy during the long holding time. 變量泵可在長的保壓時間內節省能源。
- Holding time is determined by the solidification time of the gate. We decide it according to the weight. 保壓時間的確定以澆口冷凝為依據。通過產品稱重來確定。
- Filling on-site provides higher purity, longer holding times, lower pressure rise, no transport damage, less administration and handling. 現場充裝提供高純度,長久持續時間,低壓力上升,無運輸損壞,更少的管理和操作等特點。
- Attention: The holding pressure will affects the holding time. The higher holding pressure the longer holding time. 注意:保壓壓力會(huì )影響保壓時間的長短。保壓壓力越大保壓時間越長。
- A holding pressure unit allows the pre-plasticizer or a reciprocating screw to plasticize during the long holding time. 保壓裝置使預熔器或往復螺桿在冗長的保壓時間內加料。
- To attain the similar max load stress, the holding time of PCH process was shorter than HP. 相同燒結溫度和燒結壓力的條件下，要想獲得可承受近似壓力的試樣，PCH過程的燒結時間遠遠短于HP過程。
- The effect of holding time on intergranular phase and mechanical property of GPS silicon nitride ceramics was studied. 研究了保溫時間對氣壓燒結(GPS)氮化硅陶瓷晶界相及力學性能的影響。
- The effects of stressing rate,holding time and loading path on ratcheting were discussed in the paper. 揭示了材料在不同加載速率、不同保持時間以及不同加載路徑下的棘輪變形特性。
- The plasticized melt accumulates in front of the plunger. Only during injection (including holding time) is plasticizing stopped. 已塑化的熔融累積在注射柱塞的前面。只是注射時(含保壓)不加料。
- The optimum concentration of Changcheng 3# or Lan-826 was 0.3%, acid pickling temperature was 60? and its holding time was less than 5 hours. 長城3%23或蘭-826的最佳添加量為0.;3%25，最佳酸洗溫度為60℃，酸洗時間小于5h。
- The result holds times pulsation closely, go in times front row forever. 結果緊緊把握時代脈博,永遠走在時代前列。
- The hold time is the amount of time a router treats a neighbor as reachable and operational. 保持時間是路由器把一個鄰居視為可以到達和操作的一段時間。
- The relation between survivors of microorganisms and processing pressure as well as holding time during UHP treatment to Kiwi juice was investigated. 探討了熱敏性純獼猴桃汁在超高壓處理過程中,存在的菌落總數和大腸菌群數隨壓強大小和加壓時間變化的關系。
- The result indicates that under different quenching temperature and holding time , the formed bainite morphology are different. 結果表明,在不同淬火溫度和保溫時間下形成不同的貝氏體形貌。
- If EIGRP does not receive a packet from a neighbor within the hold time, EIGRP considers that neighbor down. 如果EIGRP在保持時間內沒有從一個鄰居那里收到封包，EIGRP會(huì )認為那個鄰居是當掉的。
- When the hold time expires, DUAL is informed of the topology change, and must recalculate the new topology. 當保持時間終止時，DUAL會(huì )被告知拓撲已經改變，并且必須再重計算新拓撲。
- The influences of foaming and holding time on bubble diameter and the property of devitrified foam glass have been studied. 介紹了梯溫爐的結構及原理,根據測量結果繪制了發泡溫度與泡徑的關系曲線。
- Then the temperature is higher than 10 degrees for charring, long holding time, and then formed with graphite structure (conductive) of charcoal. 再經溫度高于1000度以進行炭化，保溫時間特長，然后形成帶石墨結構(導電)的木炭。
- The result shows that the void content decreases while the crystallinity and the tensile strength increases with the increase of the holding time. 研究結果表明,隨著保溫時間的增加,復合材料的空隙率降低,結晶度和強力增加;
