您要查找的是不是：
- Here, cooling time is defined as holding time. 在這里，冷卻時間定義為保壓時間。
- CHANNEL HOLDING TIME CHARACTERIZATION; DWELL TIME DISTRIBUTIONS; TELETRAFFIC PERFORMANCE; TELETRAFFIC ANALYSIS; WIRELESS CELLULAR COMMUNICATION 信道占用時間特征；接通時間分布；電信業務行為；電信分析；無線蜂窩通訊。
- The formula of Erlang B is inferred to hold for any M/G/C/C system with general service time distribution,but rigorous proof is absent. 理論上推測Erlang B公式對服務時間為任意分布的M/G/C/C系統的呼叫損失概率是有效的但缺乏嚴格證明。
- Results indicated that activation temperature, temperature holding time and activation agent ratio determined the depth of activation and the micropore distribution. 實驗結果表明，活化劑用量、活化溫度和活化時間都決定著活化反應的深度。
- A variable displacement pump could save energy during the long holding time. 變量泵可在長的保壓時間內節省能源。
- The stress distribution in greenware was analyzed and the effects such as linear heating rate, holding time heating, mass loss rate controlled program on the stress was investigated. 結果顯示,生坯內氣體壓力、徑向應力、切向應力分布呈現中高外低分布,徑向應力在生坯表面為零,而切向應力在表面不為零。
- A multistage operation greatly narrows the residence time distribution and cut down this bypassing. 多層操作可使停留時間分布大大地變窄，并截斷短路。
- A residence time distribution mathematic model by continuous-time Markov chain was built up. 將連續時間馬爾科夫鏈與多級全混流串聯模型結合建立停留時間分布數學模型。
- The time distribution of the ith new type failure for Markov repairable systems was studied. 對馬爾可夫可修系統新類型故障發生時間的分布問題進行研究。
- Holding time is determined by the solidification time of the gate. We decide it according to the weight. 保壓時間的確定以澆口冷凝為依據。通過產品稱重來確定。
- Furthermore, the time of plagioclase time distribution can be found by terrane age detection. 此外，可以通過巖層年齡測查找到斜巖時間分布的時間。
- Attention: The holding pressure will affects the holding time. The higher holding pressure the longer holding time. 注意:保壓壓力會(huì )影響保壓時間的長短。保壓壓力越大保壓時間越長。
- And the gas residence time distribution of the separator was studied by using scalar transport equation. 并且用標量輸運方程研究了氣體在旋流快分器內停留時間的分布規律。
- A holding pressure unit allows the pre-plasticizer or a reciprocating screw to plasticize during the long holding time. 保壓裝置使預熔器或往復螺桿在冗長的保壓時間內加料。
- The concept of Residence Time Distribution (RTD) with a certain extent of back-ndxing was introduced. 將“停留時間分布（RTD）”概念引入換熱過程研究。
- Delay time distribution of MWPC has been measured systematically,and experi-mental results have roughly analyzed. 本文較系統的測量了多絲正比室的延遲時間分布,并對實驗結果予以粗略的分析。
- To attain the similar max load stress, the holding time of PCH process was shorter than HP. 相同燒結溫度和燒結壓力的條件下，要想獲得可承受近似壓力的試樣，PCH過程的燒結時間遠遠短于HP過程。
- The effect of holding time on intergranular phase and mechanical property of GPS silicon nitride ceramics was studied. 研究了保溫時間對氣壓燒結(GPS)氮化硅陶瓷晶界相及力學性能的影響。
- The effects of stressing rate,holding time and loading path on ratcheting were discussed in the paper. 揭示了材料在不同加載速率、不同保持時間以及不同加載路徑下的棘輪變形特性。
- The manufacturing company has introduced a Just in Time system of distribution. Briefly explain what is meant by Just in Time distribution. 該企業在產品分銷中引入了準時制系統。請簡要解釋準時制分銷。
