您要查找的是不是：
- Remove the body bolts from the valve body. 從閥體上拆卸閥體螺栓。
- Lift retainer and check assembly from valve body. 從閥體內取出護圈和止回閥總成。
- Screw the cover onto the valve body. 將閥蓋旋在閥體上。
- Turn handle to be perfectly perpendicular to valve body. 將手柄旋轉到與閥體完全垂直的位置。
- Remove the body bolts from valve body using Allen Key. 采用內六角扳手從閥體上拆卸閥體螺栓。
- Installation suggestion: valve body vertical and upward. 建議安裝方式，閥體垂直向上。
- IMPORTANT! Flow must always be in direction of arrow on valve body. 重要提示！水流流向必須與閥體上的箭頭方向一致。
- After opening the cylinder, it was found that the No. 2 governor valve's washers fell off and crushed into the cylinder, thus made flow area of turbine reduce. 揭缸檢查發現%232調速汽門閥芯的止退墊片脫落，造成汽輪機通流面積變小。
- Insert valve body through mounting hole and seat lugs. 將閥體插入安裝孔和密封連接盤。
- Press stem/ball into valve body and remove from open end. 將閥桿/球體壓入閥體內，并且從開口端卸下來。
- The top of retainer must drop just below threads in the valve body. 護圈上方必須放置在閥門閥體螺紋以下。
- Slide one half of the splash guard into the groove on the relief valve body. 將防濺保護的一半滑動到安全閥閥體的溝槽上。
- Pressure governor valve is composed by governing valve, oil, water separation devices and a combination of one-way valves, etc. 調壓閥是由調壓閥、油水分離器及單向閥等構成的一個組合閥總成。
- Linear rails increase the precision of the plant, all joints, the governor valves are used PISCO brand, quality and performance guarantee stability. 采用線性導軌增加機臺的精密度，所有接頭、調速閥均采用PISCO品牌，保證品質與性能的穩定性。
- Install valve in the direction of the flow arrows on the valve body. 按照閥體上的箭頭方向安裝閥門。
- Assigning the ideally fitted wedge, ground and lapped, to proper valve body. 將研磨后的楔板分配到最適合的閥體上。
- Reinstall the valve body and union nuts only after the joint has fully cured. 只有在連接完全成功粘固后，才能夠重新安裝閥門閥體。
- Design of the Governor Valve for Spare Steam 備用汽源調節閥的設計
- Control of Leakage Flowrate of Governor Valve 調速閥內泄漏量控制試驗
- Gear operator is removed by unscrewing hex head screws which hold operator to valve body. 通過擰松將操作機構固定在閥體上的六角螺栓來拆卸齒輪操作機構。
