您要查找的是不是：
- Analytical calculation of pocket-step-bush gas lubricated thrust bearing 袋式階梯瓦氣體止推軸承的分析計算
- gas lubricated thrust bearing 氣體止推軸承
- Finite element method is employed to solve Reynolds equation and investigate dynamical performance of two way herringbone grooved liquid lubricated thrust bearing(HGTB). 采用有限元法解雷諾方程 ;研究了雙向人字槽液體潤滑止推軸承的承載力、軸向剛度系數和阻尼系數 ;并與相同參數下正轉、反轉的單向人字槽止推軸承進行比較 .
- Simplified Calculation of Subsonic Velocity Field of Externally Pressurized Gas Lubricated Circular Thrust Bearings 圓盤止推靜壓氣體軸承亞音速流場的簡化計算
- Optimum Design of Externally Pressurized Gas Lubricated Circular Thrust Bearings with Several Inherent Compensation Supply Hole 多供氣孔靜壓圓盤止推氣體軸承的參數設計
- air lubricated thrust bearing 空氣潤滑止推軸承
- The radial and thrust bearings are permanently lubricated. 徑向軸承和止推軸承都是終身潤滑。
- Actual deviation of height of the spherical plain thrust bearing. 推力關節軸承實際高度偏差。
- Heavy-duty thrust bearing; locked to prevent axial movement. 堅固耐用的止推軸承;鎖定后有利于阻止軸向運動。
- The safety running of hydrogenerator needs thrust bearing sharing thrust load. 水輪發電機組的正常運轉要求各推力軸承軸瓦應均勻地承受推力負荷。
- Remove thrust bearings from rear main bearing carrier. 從后主軸承托架上拆下止推軸承。
- In addition to the new aerodynamic foil journal bearing with elastic support, the spiral groove thrust bearing was also applied to the self-acting gas bearing turboexpander in the air refrigerator. 并采用平面螺旋槽動壓氣體止推軸承，對空氣制冷機用透平膨脹機進行了全動壓氣體軸承支承的研究。
- Application of Micro-displacement Actuator on Hydrodynamic Lubrication Thrust Bearings 微位移驅動器在止推油膜軸承中的應用
- How many radial (axial ) clearnance are there in this bush (journal bearing, thrust bearing)? 這個軸套(軸頸軸承、止推軸承)的徑向(軸向)間隙是多少?
- When the load is purely or predominantly axial then the choice should be a spherical plain thrust bearing (fig 9). 當負荷是純軸向負荷或主要是軸向負荷時,應選擇球面滑動推力軸承(圖9)。
- This paper presents the hardness and precision of the thrust bearing runner for hydro-generator and characteristic of thrust bearing, and analyses it. 介紹了大型水輪發電機鏡板硬度和精度的概況及推力軸承的特性,分析了鏡板的硬度和精度的限值。
- Each of the four legs contains a simple screw jack with a thrust bearing that is operated telescopically inside of two tubes. 四條腿中每個都裝有一個簡單的螺旋千斤頂，千斤頂中又有一個在兩根管道中做伸縮操作的推力軸承。
- Secondary development was carried out by combining the methods of finite element analysis (FEA) about gas lubrication with the slide bearing analysis module of Marc. The static properties of aerostatic bearing were obtained. 利用通用有限元軟件Marc中的滑動軸承模塊,結合氣體靜壓潤滑問題的有限元理論分析方法,對該模塊進行二次開發,求得氣體靜壓軸承的靜態特性,并通過實驗加以驗證。
- Fourka, M. and Bonis, M., “Comparison between Externally Pressurized Gas Thrust Bearings with Different Orifice and Porous Feeding Systems”, Wear, Vol.210, 1997, pp.311-317. 蔡龍升，“具自動補償與微細化節流器之氣體軸承開發”，中正大學碩士論文，2000。
- Production and application of thrust bearing,and guide bearing made of filled PTFE in submarine motor pump are introduced. 介紹了潛水泵中止推軸承與導向軸承用填充聚四氟乙烯材料進行的生產和應用。
