您要查找的是不是：
- For instrument with individual pressure regulating needs, gas outlet points on benches shall be terminated with an individual regulator bracketed to the bench. 工作臺上氣體出口龍頭由單獨的閥門來控制。
- Low table by adjusting the outlet pressure control screw. 低壓表的出口壓力可由調節螺桿控制。
- Open the second sterile pouch and connect the tubing to the insufflator’s gas outlet. 打開第二個消毒袋，把管系連接到注氣器出氣口處。
- Primary sign performance: The valve is designed with proper jet selection to control outlet pressure. 本閥主要特點:本閥通過噴射裝置來實現控制出口壓力的功能。
- Note: Net lift and installation efficiency can not be calculated because outlet pressure is controled by catcher. 注:因出口壓力由閘閥控制,凈揚程和裝置效率無法計算。
- Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure. 通過從最大進口壓力減去所需要的出口壓力來計算壓差。
- Find the number on the pressure difference line and note the outlet pressure index number. 找出壓差線上的數字，并且注意出口壓力指數。
- QFH maintains the stable outlet pressure regardless of the fluctuation of inputting pressure or flow rate. 當輸入壓力和流量波動時，總能保持穩定的輸出壓力；
- Like the single-stage regulator, outlet pressure from the first stage of the two-stage regulator rises as cylinder pressure decreases. 同單級調整器一樣，兩級調整器的第一級的出口壓力隨鋼瓶壓力的降低而升高。
- Check Pressure Drop (inlet-outlet) to insure that desired outlet pressure is above the recommended lowest outlet setting to avoid cavitation conditions. 止回壓降(進口-出口)確保所需的出口壓力處于推薦的最低出口設置點上,以避免空穴現象發生。
- The effects of inlet velocity, outlet pressure, opening size as well as cone angle on cavitation intensity in the water hydraulic poppet valve were numerically investigated. 分析了進口流速、出口壓力、閥口開度和閥芯錐角對純水液壓錐閥閥口氣穴強度的影響。
- The adjustment of outlet pressure of regulator can be made by adjusting screw of sensor pilot manually, or remote actuated by using pneumatic or electronic signal devices. 控制壓是藉感應先導器調整彈簧而設定，也可由氣動或電信號方式進行遠程調整控制。
- The gas distribution system shall cover from the gas outlets on the benches or fume hoods to gas regulator manifolds at the cylinder area. 氣體管路安裝從氣瓶站總閥門到工作臺上各個氣體閥門。
- Manifold shall have safety pressure relieve valve, pressure regulators, and pressure gauges indicating inlet and outlet pressure, bleed valve (vent valve) and pigtail for cylinder connections. 氣體管路需要有安全壓力釋放閥門、壓力調節閥門、壓力表來指示氣體壓力。
- The test results have proved that the flow rate widely varied and the pump efficiency is high when the pump outlet line structure was altered and the outlet pressure was controlled in a special limit. 試驗結果表明，改變泵出口管線結構，使泵出口壓力在一定范圍內工作時，流量變化大，而且泵效率較高，可以作為泵調整參數的一種手段；
- Manifold shall have safety pressure relieve valve, pressure regulators, and pressure gauges indicating inlet and outlet pressure , bleed valve (vent valve) and pigtail for cylinder connections. 氣體管路需要有安全壓力釋放閥門、壓力調節閥門、壓力表來指示氣體壓力。
- Use the cavitation chart and determine if the intersection of the inlet and outlet pressures falls in the shaded area. 采用空穴圖表并且確定進口和出口壓力的相交是否落在陰影區域內。
- The gas is stored under pressure in the tank. 該氣體在壓縮狀態下貯存于罐中。
- By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV). 根據黑箱理論提出將閥前壓力、閥前過冷度、閥后壓力和膨脹閥流通面積作為膨脹閥流量系數的影響參數。
- FAILURE ANALYSIS ON DISABLED SEAL OF CATALYST GAS OUTLET VALVE 催化裝置煙氣管線閥門失效分析
