您要查找的是不是：
- A joint J is typical of those at which there is no external load. 節點J是無外荷載作用的典型節點。
- The liquid's motion induces a streaming current that is fed through an external load resistor to harvest electrical energy from the fluidic system. 液體運動產生的電流流經一個外加電阻，便可從流體系統中收取電能。
- Load current is set in 1.56% increments of the maximum value. 負載電流在最大值增量的1.;56%25中設置。
- Moisture proof and no contact output, Load current 1A max. 具防潮功能并且采用無接點方式，限時控制負載電流最大1A.
- The method can be applied to slopes with any configuration, different layering and external load distribution. 該方法適用于任意幾何形狀、不同巖土材料分層以及多種荷載作用的復雜邊坡。
- The mudstone can slake severely under the conditions of unloading,weathering,water and external load effect. 通過掃描電鏡和X射線衍射,分析底板泥巖的礦物組成,并對其泥化機制進行研究。
- When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 訂購過載繼電器時，請注明每臺電機的功率馬力、電壓和滿載電流。
- The load current is handled directly by the controller through semiconductor switching devices. 負荷電流由調節器通過半導體開關元件直接控制。
- When actuation device stops at any position, a locking function is applied to avoid the displacement of actuation device due to external load. 其可使執行機構在任意位置停止后,加以可靠的鎖定作用,從而避免執行機構在外界載荷作用下可能發生的位移。
- It is obvious that a concrete member cracks in tensional area as the external load comes to 14% of its ultimate load or so. 研究表明，當外荷載為極限荷載的14%25左右時，鋼骨高強混凝土構件受拉區混凝土開裂；
- The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors. 用戶可通過選擇參考電壓和電流感測電阻設置峰值載荷電流限制。
- A family of straight lines (passing through origin) of the indenter's curvature versus the external load under different contact zone is obtained. 由此可以得到以接觸區尺寸為參數的接觸 壓力與壓頭曲率的關系直線族。
- But this method is not suitable for the case where the external load is transmitted via a chain of parts with clearances existing at their joints. 但當外加載荷是通過幾個聯接處有較大間隙的零件傳遞至螺栓時，這種分析方法就不再適用。
- An "Overcurrent Relay" is a type of protective relay which operates when the load current exceeds a preset value. 過電流繼電器是繼電保護裝置的一種，當負載電流超過整定值時，繼電器動作。
- Under the influence of the external loads, the body B moves and deforms. 在外加負荷的影響下，物體b將運動和變形。
- Choosing the load current phasor as the reference for the phasor diagram analysis is straightforward and effective. 以負載電流相量為參考的新的相量圖分析方法是簡潔有效的；
- And the displacement of MFPs is very small under the random external loadings. 同時，在同樣的隨機載荷作用下，巨型框架抗振平臺具有比較小的振動位移。
- Under the influence of the external loads , the body B moves and deforms. 在外加負荷的影響下，物體B將運動和變形。
- The current distribution in fuses is discussed when high frequency components are present in the load current. 還討論了在負載電流中引入高頻分量時熔斷器中的電流分布問題。
