您要查找的是不是：
- engine water outlet hose connection 發動機出水軟管接頭
- The waste water outlet jammed suddenly. 廢水出口突然堵了。
- So, a compound control method, which combines the open loop control with closed loop control, is put forward to control the temperature of cooling water outlet engine. 因此,對缸套冷卻水出口溫度的控制提出了采用開環控制和閉環控制相互配合的復合控制。
- A combination anode rod/hot water outlet nipple has been installed to extend tank life. 為了延長內膽使用壽命,本熱水器安裝了組合型陽極棒/熱水出口螺紋接頭。
- The hot water outlet and cold water inlet are identified on the back panel of the heater. 這種類型熱水器的熱水出水口和冷水進水口位于熱水器的面板后部。
- It is higher anti-eroding, changeless, without crack, forms a complete set with zirconic given-diameter water outlet. 具有較高的耐浸蝕性，與鋯質定徑水口配套使用，有不變形、無裂紋等優點。
- Calibrate the mixed water outlet temperature by placing a thermometer in the mixed water stream. 在混合水流內放置溫度計，校準混合水出口的溫度。
- Diesel engine water preheating system can ensure start in low temperature areas. 柴油機水預熱器系統可確保嚴寒地區低溫起動。
- After soldering, flush piping and install valve using filter washer on hot and cold water inlet and fiber washer on the mixed water outlet. 焊接后，沖洗管道，隨后采用熱水和冷水進口處的過濾器墊圈和混合水出口處的纖維墊圈安裝閥門。
- A water-cooling system consists of the engine water jacket, thermostat, water pump, radiator, radiator cap, fan, fan drive belt and neccessary hoses. 一個完整的水冷系統包括機體水套，節溫器，水泵，散熱器，散熱器罩，風扇，風扇驅動皮帶和必需的水管。
- Filter start-up after stopping the washing equipment and closing the corresponding valves before opening the filtered water outlet valve. 啟動濾池時，在開啟濾后水出口閥前，停止沖洗設備并關閉相應的閥門。
- Wushe reservoir has a gravity dam with a linear shape and thick base. 6.Atop the dam is a water outlet to relieve flooding. 7. 圖5：霧社水庫采用混凝土重力壩，壩型呈直線，底厚上薄，重心在壩底，圖6：霧社水庫壩頂排洪道。
- A series of know-hows of MCU are applied on the system and captures sucessfully real-time data of engine water termperature and and process and display this data recorded. 該系統采用了一系列的單片機技術，實現了發動機水溫信號的實時采集、數據處理、顯示。
- It is used with integral plug and soaking water outlet to form a complete set, anti-eroding, anti-erosive, without coming-off, without bursting. 本產品在連鑄澆注過程中與整體塞棒.;浸入式水口配套使用，無脫落，無炸裂，抗侵蝕、耐沖刷等特點。
- Closing the filtered water outlet valve and lowering of the water level in the filter by opening the washwater discharge valve. 關閉濾后水出口閥門，通過開啟沖洗水排放閥降低濾池內的液位。
- Scrub the internal wall of the urinal. Pay attention to clean the covering bowl, water outlet and sewage outlet, wash out with water after scrubbing. 擦拭小便池內壁。注意清潔遮擋的半球體、出水口和下水口，擦拭后用清水沖洗。
- Switch on the power to start the pump, through the rtanslucent water outlet check it the lamp lights and the pump works, if all condition is normal, put it into operation. 接通電源及啟動水泵,觀察透明出水口,檢查燈管是否發亮,水泵能否工作。一切正常,方可投放入使用。
- Connection between handrail and platform beam shall be welding. It shall be 8mm weld around the base plate of past on side.There shall be gap for water outlet. 立柱與扶手管、橫桿間采用銷釘固定或焊接固定的方式，具體的連接方式見后面的的詳細要求。
- Dual fireproof oil reservoirs should be designed,and the oil inlet height should not be lower than that of the water outlet to siphon oil in and drain water off. 防火油池應進行雙池設計,兩池中進油口和出水口不應同高或進口低于出口,這樣才能形成虹吸排水貯油現象;
- Fill your radiator with water, or your engine will overheat. 給你的散熱器充水，否則引擎會(huì )過熱。
