您要查找的是不是：
- This paper introduces the characteristic of electromagnetic pulse produced during electrostatic discharge(ESD EMP). 介紹了靜電放電電磁脈沖 ( ESD EMP)的特性。
- Electromagnetism pulse produced during electrostatic discharge (ESD EMP) has sharp rise edge, wide frequency band and high peak. It can disturb and destroy the electronic system. 靜電放電產生的電磁脈沖 ( ESD EMP)有上升沿陡、頻帶寬和峰值大等特點 ,對電子系統的干擾和破壞很大。
- Available with earth terminal for electrostatic discharge. 有接地腳型,利于靜電釋放。
- Are electrostatic discharge sensitive parts adequately controlled? 對于靜電放電敏感的部件是否得到有效控制
- It is just the electrostatic discharge (ESD) result in the harm. 在電子工業中，靜電危害主要表現為靜電放電。
- ESD commonly also stands for electrostatic discharge. ESD有的時候是表示靜電放電。
- Electromagnetic pulse produced during electrostatic discharge ( ESD EMP ) has sharp rise edge, wide frequency band and high peak. It can disturb and destroy the electronic system of the weapon equipments. 靜電放電產生的電磁脈沖 (ESD EMP)具有上升沿陡、頻帶寬和峰值大等特點 ,它對武器裝備的電子系統具有很強的干擾和破壞作用。
- Enclose each drive in a SeaShell container or an ESD (electrostatic discharge) bag. 將每個驅動器裝入SeaShell容器中或ESD(防靜電)袋子中。
- Various filters, interference analyzer, near-field energy leakage tester electrostatic discharge, and EMP. 各類濾波器干擾分析儀近場（漏能）測試儀靜電放電與電磁脈沖；
- Electromagnetic pulse(EMP)generated by electrostatic discharges(ESD)can severely interfere with the normal operation of electronic systems and even damage them. 靜電放電(ESD)產生的電磁脈沖(EMP)會(huì )對電子系統的正常工作造成嚴重的干擾;甚至造成系統的損傷.
- Electrostatic discharge (ESD) is a very important technology for the interference caused in the circuit in electronic anti jamming technology. 靜電放電 (ESD)對于電路引起的干擾是電子抗干擾技術中十分重要的一項。
- Latent failure study on the low-level human body model (HBM) electrostatic discharge (ESD) stresses on micro-electric device was presented. 摘要研究了低電壓的人體模型(HBM)靜電放電(ESD)對微電子器件造成的潛在失效。
- In the course of system adjusting and properties testing, it is needed to make electrostatic discharge(ESD) experiments. 在系統調試、性能測試及工作時要進行靜電放電實驗 ,電磁輻射、干擾隨之產生。
- According to the analysis of spectrum for a series of the partial discharge pulse waveforms, the author proposed that the upper cutoff frequence of a detector should not be higher than 1 MHz and the bandwidth of the detector should not he too broad. 作者根據對局部放電脈沖波形的頻譜分析,提出檢測器的檢測頻率以低于1兆赫(1 MHz)為好,頻帶不宜過寬。
- The cause of electrostatic discharge production was introduced,and the way and method of eliminating the static electricity were discussed. 分析了靜電和靜電放電產生的機理,探討了消除電子產品靜電的途經和方法。
- After analyzing the basic principle of Electrostatic Discharge,the limitation of traditional ESD protection circuits applied in high speed circuits was pointed out in the paper. 分析了靜電放電(ESD)保護的基本原理;指出了傳統的用于模擬電路的 ESD保護電路在高速電路應用中的局限性.
- In addition to these transient triggering modes, the system-level electrostatic discharge (ESD) event has been proven a new TLU-triggering mode in this dissertation. 因此相關研究對系統或電路設計者而言非常地迫切需要，以期能提供系統層級靜電放電所引發暫態觸發閂鎖效應的相關知識及解決方法。
- Mainly introduced the physical characteristic of the electrostatic, the reason of electrostatic discharge, static accident to the electronic product and the source of static. 介紹靜電的物理特征、靜電放電的原因、靜電對電子產品的危害以及靜電源。
- By analyzing the electrostatic discharge current waveform and given parameters，have designed a kind of discharge circuit called human body/metal model. 通過對標準電流波形及給定參數的分析，設計了易于實現的人體-金屬模型放電回路。
- Using a simple electrostatic discharge (ESD) simulation and testing set-up, the characterization of air ESD specialized in IEC standard have been investigated. 利用簡單的靜電放電模擬測試裝置對IEC標準規定的空氣式靜電放電的放電特性進行了研究。
