您要查找的是不是：
- At the injection well both a gas and a liquid phase are present at equilibrium. 在注入井中，氣相和液相都處于平衡狀態。
- To solve this problem,a set of pipe-blowout preventer slip used in water injection well has bee. 為解決這一問題,設計了注水井防噴管卡瓦。
- The ion concentration of stemming at the water injection well bottom in the block of Jidong Oilfield has been tested. 對冀東油田某區塊注水井井底堵塞物的離子含量進行了測定,分析了注水井井底堵塞產生的主要原因。
- Casing damage during blowout of water injection well is common in many oil fields of China. 注水井放噴過程中的套管損壞問題在中國許多油田十分普遍。
- A deflagration-acidification complex technology is used in injection well to increase the effective penetration depth of acidification liquid. 在注水井中采用爆燃酸化復合工藝以增加酸液的有效穿透深度。
- So the verification and inquiry system for zonation test result of a injection well from the network is studied and designed. 為此,進行了注水井分層測試成果網上審核、查詢系統的研究設計。
- Field procedures of profile control disposal by Xanthan gum in water injection well are described and profile control results are analyzed. 文中著重敘述了黃原膠在棗園油田注水井調剖處理的現場施工簡況，并對調剖效果進行分析。
- In case of a condensing gas drive, the original reservoir fluid and the injection gas are not miscible, but miscibility may be achieved at a later time, at the injection well. 如果進行凝析氣驅?zhuān)⑷刖械脑家后w與注入氣在起初是不可能混相的，但過一定時間混相則可能發生。
- From the results of the first and second addition of TX-100 into sand box through injection well showed the mobility of TCE was not significantly different. 分兩次添加TX-100，實驗結果顯示第二次注入與第一次注入的TX-100對TCE的增溶效果差不多并沒有明顯的改變。
- The paper analyzed three kinds of accidents that affect ground water-resource during oil field exploitation, indicted the greatest risk was the leakage of the injection well wall. 分析了在油田開發工程可能對水源地產生影響的三類事故,篩選出風險最大的事故是注水井井壁泄漏事故。
- In order to improve water injection profile, many packers and water allocators have been applied in water injection well to inject quantitatively into different reservoir intervals. 為改善注水井吸水剖面,在注水井上應用多個封隔器和配水器,對不同的油層層段進行定量注水。
- I am well aware that this is a tough job. 我深知這是一件棘手的工作。
- Engineers are worried that CO2- laden brine, which is acidic, could find its way from an injection well to an abandoned well and thereupon corrode the cement plug and leak to the surface. 工程師擔心充滿二氧化碳而呈酸性的鹵水，可能循著某種途徑從注入井進入廢棄油井，隨后腐蝕水泥封蓋而洩漏至地表。
- On the basis of theoretical analysis and the statistics of actual production data, we find out the exponential relationship between the concentration of polymer solution and the distance to injection well. 在理論分析和實際生產數據統計的基礎上 ,確定了聚合物溶液質量濃度與其到注入井距離之間的變化呈現指數關系 ,且聚合物溶液冪律指數與聚合物溶液的質量濃度之間也呈指數變化關系 ;
- The testing tool was applie d to more than 200 injection wells in 19 98 and 1999 respectively for profile con trol. 1998年和1999年在濮城油田應用該測試儀分別對200多口井進行調剖取得明顯效果。
- For water injection wells, some technologies such as CDG gel, polymeric compound driving, profile control and acid... 對這些措施的效果進行了分析和比較表明,CDG凝膠、聚合物驅及側鉆工藝應是今后主要采取的增產措施。
- Alkaline silicic acid gel is used for water control in producing wells and profile control in water injection wells. 堿性硅酸凝膠多用于油井堵水或水井調劑。
- The bread crisped up for you didn't wrap it well. 你沒把面包包好，它變干了。
- After oilfield is put into development by water flooding, the water injection system would be easily to form scaling, which seriously affects the operation of the surface water injection system and the water absorbability of the water injection well. 摘要油田投入注水開發后，注水系統容易結垢，嚴重影響地面注水系統運行和注水井吸水能力。
- One can not learn a language well unless one works hard. 學好一種語言非下苦功不可。
