您要查找的是不是：
- Onboard oxygen generating system can satisfy the request of inlet pressure. 機載產氧系統可以在有限的供氣壓力下滿足要求。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 對于可壓縮性流體,如果壓降超過進口壓力的一半。
- The filter meshwork of the compressor inlet was cleaned out without shutdown of CCR plant.The method, that the plant was run in longer workup period, was found in it. 介紹在裝置不停工狀態下,進行壓縮機入口過濾網的清洗工作,并從中找到使裝置長周期運行的方法。
- Essentially balanced single seat minimizes a variation in delivery pressure resulting from a varying inlet pressure. 基本平衡單閥座最大限度減小進口壓力變化對輸出壓力的影響。
- The effect of the inlet pressure on the performance of the vortex tuba which was designed by author was investigated by experiment with air as medium. 摘要采用自行設計的渦流管，并以空氣作為工作介質，通過實驗研究了在保持膨脹比不變的情況下，不同進口壓力對渦流管性能的影響。
- An essentially balanced single seat minimizes variation in delivery pressure resulting from varying inlet pressure. 一個基本平衡的單閥座最大限度減小進口壓力變化對輸出壓力的影響。
- Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure. 通過從最大進口壓力減去所需要的出口壓力來計算壓差。
- The inlet pressure sensor is fixed to a inlet pipe directly with a boltand prevent gas leak through two seals. 進氣壓力傳感器是用一個螺栓直接固定到進氣管上，并通過兩個密封圈來防止漏氣。
- The valve opens for tank discharge when tank head pressure is greater than valve inlet pressure. 當容器水頭壓力大于閥門進口壓力時，閥門開啟進行容器排放。
- LCIT Load Compressor Inlet Temperature 負載壓縮機進口溫度
- The first stage reduces inlet pressure to a preset intermediate pressure, typically 350 to 500 psig. 第一級把入口的壓力降到預定的中間壓力，該壓力典型值為350到500psig。
- Relative to uniform inlet pressure, the distorted or actual profiles may have a rather profound effect on engine performance. 與均勻的壓力分布比較起來，畸變的或真實的壓力場對發動性能具有相當大的影響。
- Under a fixed bigger expansion ratio, the cooling performance of the vortex tube increases with the increase of the inlet pressure. 膨脹比為3時，進口壓力的增加基本不影響渦流管的制冷性能，而膨脹比為6時，隨著進口壓力的增加，渦流管的制冷性能顯著提高。
- Some factors of effect i.e. cavitation number and inlet pressure are discussed and the decompositional regular is proposed. 同時;探討和分析了空化數和進口壓力等因素對其降解的影響;提出了水力空化降解與時間的規律.
- This paper introduces the method of casing pressure drop which can be used to measure pump inlet pressure and flow pressure at well bottom. 闡述了套壓降低法測泵口壓力和井底流壓的基本原理、測試方法以及相關的資料處理和計算方法。
- The ignitor can work reliably when inlet pressure of hydrogen and oxygen changed and even when back pressure rise up quickly. 點火器抗系統干擾能力強，點火器出口反壓快速增長時，點火器不會(huì )熄火，仍能持續提供穩定的氫氧火炬。
- Norminal frequency calculation of compressor inlet air washing tank 壓縮機進氣洗滌罐的固有頻率計算
- They are also used in conjunction with high-pressure cylinder regulators that limit the inlet pressure to 250 to 400 psig. 它們還和把入口壓力限制在250到400psig之間的高壓鋼瓶調整器聯合使用。
- ACTIVE CONTROL OF INLET DISTORTED FLOW FIELD IN COMPRESSOR INLET 壓氣機進口畸變流場的主動控制
- Introduction of M701F Gas Turbine Compressor Inlet Guide Vane(IGV) M701F燃氣輪機壓氣機入口可變導葉機構介紹
