您要查找的是不是:
- basal seat area 基座區; 基托區; 義齒基托; 承受區; 承托區
- Dentistry - Denture base polymers. 牙科。假牙用樹脂。
- The cap was made of permanent soft-liner in the denture base. 固位帽由永久軟襯直接襯于義齒組織面構成。
- Erratic operation is usually caused by dirt in seat area. 閥座區域內的污垢通常會導致不穩定的運行。
- Conclusion The microwave energy is a good heat source in cured denture base materials. 結論微波能是一種良好的固化義齒基托材料的熱源。
- Inspect machined seat area for nicks and mineral build up clean with emery cloth. 檢查機加工閥座區域是否有砂布清洗后留下的刻痕或礦物。
- Objective To observe the mechanical properties and the change shrinkage of microwave-cured denture base resins. 目的了解微波能加熱處理義齒基托材料的力學性能和收縮變化。
- Objective To investigate the factors that have effects on the quality of MMA denture base forming. 目的探討影響義齒塑料基托成型質量的原因。
- Coated waterway in the seat area is smooth,free of cavities and unobstructed thru port to maximize flow. 閥體流道上無凹槽且光滑,同類產品中其流阻最小。
- Thoroughly clean the seating area. 徹底清洗閥座表面。
- Once again, close adaptation of the denture base to the mucosa will enhance these forces. 同樣,基托與粘膜間良好的密合性可增強表面張力。
- Thoroughly clean the seat area and clapper sealing surfaces, check arms, and O-rings for damage, nicks, and debris. 徹底清洗閥座面和閥瓣密封面,止回閥臂和O形環,檢查是否有損壞、刻痕和碎片。
- Polymethyl methacrylate is the most frequently used denture base material in clinic. 聚甲基丙烯酸甲酯是臨床上最常用的義齒基托材料。
- The opening force available is essentially equal to the seat area times the tank pressure. 這個打開閥座的作用力基本上等于閥座面積乘以儲罐壓力。
- It was important to polish the denture base surface to decrease the adherence of Streptococcus. 提示應重視提高義齒表面光潔度,以減少菌斑附著。
- Saliva wets mucosa very effectively, but is less effective on denture base resins. 唾液可以高效的潤濕粘膜,而潤濕義齒基托樹脂的效率卻較低。
- Objective To study the antibacterial activity and prolonged effects of denture base resin containing silver. 目的研究載銀基托樹脂的抗菌性及長效性。
- The seat area of the integral body design minimizes pockets where material can accumulate. Illustration above shows direct flow configuration. Reverse flow options are available. 整體閥體結構的閥座區域能夠最大限度消除可能產生淤積的死角。上列插圖顯示直接流向結構??梢蕴峁┠媪骰虻沽鹘Y構供選擇。
- Methods The flecture strength, hardness and shrinkage were compared in using microwave-cured and water bath-cured denture base resins. 方法采用微波能和水浴兩種方法加熱固化義齒基托樹脂,進行撓曲強度、度和收縮率的對比分析。
- Methods: To make periodontal splint by extension the length and width (especially extend to occlusal surface)of the elastic denture base . 方法:通過延長彈性義齒基托的長度和寬度(向(牙合)面延伸),形成牙周夾板。