您要查找的是不是：
- Axial displacement also reduces the radial clearance. 軸向偏移還減小徑向游隙。
- Usually these bearings are arranged in pairs either back-to-back or face-to-face, and one bearing ring is axially displaced until a given clearance or preload is attained. 通常這些軸承是背靠背或面對面配對,其中一個軸承圈為軸向位移,直至達到選定的游隙或預負荷。
- The correct fit is achieved by controlling the axial displacement of the bearing from a predetermined position. 通過控制軸承相對于預定位置的軸向位移,可實現正確的配合。
- Afterwards the pipes will have to be secured against axial displacement by means of a clamping device. 然后管材必需通過夾緊裝置成軸向的轉移。
- Misalignment as well as axial displacement influences the axial positions of the rollers in a CARB bearing. 軸向偏移以及對中誤差會(huì )影響CARB軸承中的滾子軸向位置。
- The axial displacement and radial clearance are shown as functions of the bearing width. 軸向偏移和徑向游隙表現為軸承寬度的函數。
- The limited axial displacement of bearings is gener-ally allowed.However they cannot sustain axial loads independently. 該種軸承安裝、拆卸方便，耐沖擊，剛性好，軸向一般可以有限量的位移，不能單獨承受軸向負荷。
- Where larger axial displacements can occur, it is recommended to observe the information in the section "Space at the sides of the bearing". 在可能發生較大軸向位移的情況下,建議查閱“軸承兩側的空間”一節中的內容。
- This also is the case with CARB toroidal roller bearings, which will lose their axial displacement properties when filled with Solid Oil. CARB圓環滾子軸承也是如此,如填入Solid Oil,將失去其軸向位移性能。
- Determined values of the requisite oil pressure and the axial displacement for the individual bearings provide accurate positioning of the bearings. 必要的油壓和單個軸承的軸向位移,這些確定的數值可以為軸承精確定位。
- The limits are valid for bearings before mounting under zero measuring load, and with no axial displacement of one ring relative to the other. 在測量負荷為零、而且一個套圈相對于另一套圈無軸向位移的情況下,這些限值對安裝前的軸承有效。
- The load carrying capacity of the CARB bearing is very high even when it has to compensate for angular misalignment or axial displacement. CARB軸承的負荷能力極強,即使在不得不彌補角位移或軸向位移時也是如此。
- In SKF roller bearing units the necessary axial displacement occurs between the bearing outer ring and its seating in the housing bore. 在SKF滾子軸承單元中,軸承的外圈與其在軸承座孔中支承面之間會(huì )發生必要的軸向位移。
- Axial displacement of one ring relative to the other will gradually reduce the radial internal clearance in a CARB bearing. 一個套圈相對于另一套圈的軸向位移將逐漸減小CARB軸承中的徑向內部游隙。
- On the base of this, axial displacement Fault Self-Recovering (FSR) system was introduced to assure the safety and reliability of turbocompressor. 在此基礎上，引入軸位移故障自愈調控系統，從而能夠使得透平壓縮機安全高效運行。
- There are some chief conclusions: (1) Firstly eddy current sensors are put radially to measuring the axial displacement of AMB rotor. 主要成果是:(1)首次把電渦流傳感器置于轉子徑向來測量轉子的軸向位移,觀測到電磁軸承轉子軸向位移和傳感器輸出的線性關系。
- The working principle and the structure feature of rotary drum drier,and the way how to adjust axial displacement in service procedure are introduced. 介紹轉筒干燥機的工作原理,結構特點及檢修過程中軸向竄動的調整方法。
- The measuring of both axial displacement and radial displacement of the rotor forms the base of controlling the whole AMB system. 因此,對轉子軸向位移和徑向位移的檢測就成為控制整個電磁軸承系統的基礎。
- The compensator bears the pressure or thrust as long as fixed the mid supporting frame and it can only absorb axial displacement. 補償器通過受力構件來承受壓力推力，只需固定中間支架，產品只能吸收軸向位移。
- The reduction in radial internal clearance, or the axial displacement of the inner ring on its tapered seating is used as a measure of the degree of interference. 縮小徑向內部游隙或內圈在圓錐座上的軸向偏移被用作調整過盈配合程度的手段。
