您要查找的是不是：
- Let us compare our unknown analog input signal to a "guess". 現將一個未知的模擬輸入信號同一個假定值進行比較。
- The analog input signal is latched on the rising edge of CLK. 模擬輸入信號在CLK的上升沿被鎖存。
- Figure 7 shows the equivalent circuit of the analog input section. 圖7顯示模擬輸入部件的等效的電路。
- Device where analog output variable is equal to the sum, or a weighted sum, of two or more analog input variables. 一種裝置，其模擬輸出變量等于兩個或多個模擬輸入變量的和或加權和。
- The analog data path between the connector and the analog? to? digital converter in the analog input subsystem. 在模擬輸入子系統中,模數轉換器與連接器之間的模擬數字信道。
- The high level analog input is attenuated before being applied to the same modulator. 經過衰減的高電平信號也可加在同一調制器。
- I / O switch input into (DI), switching output (DO), Analog Input (AI), analog output (AO) and other modules. I/O分為開關量輸入（DI），開關量輸出（DO），模擬量輸入（AI），模擬量輸出（AO）等模塊。
- An external reference can also be applied and varied from 1 V to +VCC, with an analog input range of 0 V to VREF. 也可以使用外部基準電壓，并可在1V至+VCC范圍內變化，模擬輸入范圍為0V至VREF。
- This would also mean it would require a analog input to take a NTC or RTD for this zone to read the temperature. 這同時也意味著它需要一個類似輸入以接受該地區的NTC或RTD以讀取溫度。
- The analog input circuitry contains the analog multiplexer, the instrumentation amplifier, and the sample-and-hold circuitry. 模擬輸入電路包含模擬多路復用器，儀表放大器，以及采樣保持電路。
- The analog input is continuously sampled by an analog modulator eliminating the need for external sample-and-hold circuitry. 模擬輸入由模擬調制器連續采樣，因而無需外部采樣保持電路。
- external synchronous input adapter 外部同步信號輸入轉接器
- The part accepts an analog input range of 0 V to VDD and operates from a single +2.7 V to +5.5 V supply consuming only 9 mW typical. 該器件可接受的模擬輸入范圍為0V至VDD;采用+2.;7V至+5
- For analog inputs, any absolute voltage value above which the analog-to- digital converter cannot distinguish a change. The overload value can be different for plus and minus inputs. 就模擬輸入而言，使模數轉換器不能區別其變化的超范圍的絕對電壓值。超載值對于正輸入和負輸入可能不同。
- That is to say that it will ignore the “Bad PV” status provided with an analog input and use the actual analog numerical value. 這就是說：它將忽略“工藝測量壞值”狀態提供的模擬輸入，采用實際模擬數值。
- This allows the widest dynamic input range to the ADC.Thus, the analog input range for the parts are 0 V to VDD.The conversion rate is determined by the SCLK. 基準電壓從VDD獲得，從而為ADC提供了最寬的動態輸入范圍，因此，其模擬輸入范圍為0至VDD。
- The region controller is designed modularly, which is constituted of CPU module, digital input module (DI), digital output module (DO), analog input module (AI). 區域控制器采用模塊化設計，由CPU模塊、數字量輸出模塊（DO模塊）、數字量輸入模塊（DI模塊）、模擬量輸入模塊（AI模塊）構成。
- These modular units include analog input multiplexers, analog output devices, "blank" breadboards, signal conditioning modules for thermocouples, and so on. 這些模塊化的單位包括模擬輸入多路復用器，模擬輸出設備，"空白"面包板，熱電偶信號調節模塊等等。
- The author is going to adapt his play for television. 作者將把他的劇本改編成電視劇。
