您要查找的是不是:
- Allowable slenderness ratio of timber compression member 受壓木構件容許長細比
- He found out the best slenderness ratio of the nail. 除此之外還模擬不同材質的釘子的敲擊情形,并找出最佳的釘子細長比。
- Also analyzed are the influences of CFRP ratio, angle steel ratio, slenderness ratio and eccentricity to the mechanical properties of the columns. 分析結果表明:含碳纖維布率和含角鋼率越大,構件長細比越小,以及荷載的偏心距越小,復合加固效果越好。
- Moreover, the influence of initial crookedness would be reduced as slenderness ratio and bending moment are increased. 初彎曲對桿件的影響隨長細比和彎矩的增大而減??;
- The resista nce decreases intensely when the slenderness ratio of the hot molding sand layer increases. 阻力隨干砂層長細比的增加而急劇減小。
- The parameters used in the analyses include rise to span ratio, slenderness ratio, steel ratio and load conditions. 分析的參數有矢跨比、長細比、含鋼率以及加載方式。
- Optimal pressure and flow in high pressure water generating system were selected, and aperture / slenderness ratio of nozzle was calculated. 合理選擇高壓水發生系統的壓力和流量,計算出噴嘴的孔徑與長徑比。
- Eccentrically loaded concrete filled steel tubular(CFST) laced columns were tested with slenderness ratio as main experimental parameter. 進行了鋼管混凝土格構柱偏心受壓試驗,試驗參數為長細比。
- Experiments shows that fluidized bed supersonic jet mill has advantage in preparation of high slenderness ratio needle-like wollastonite powder. 實驗表明:流化床氣流磨在制備高長徑比硅灰石粉體時具有優勢;
- The results show that the plastic extension would not occur in tensile region until eccentricity is large and slenderness ratio is small. 研究結果表明:除相對偏心率很大及長細比很小的情況外,工字形截面偏心壓桿受拉翼緣不會(huì )進入塑性狀態;
- To study axially loaded behavior of the FRP-concrete-steel double-skin tubular long column an experiment of 3 specimens with slenderness ratio of 16. 為研究FRP-混凝土-鋼雙壁空心管長柱的軸心受壓性能;完成了3根長細比分別為16.;8、16
- How to improve the designing methods of die used for bigger slenderness ratio half hollow aluminium profile are expounded. 闡述了如何提高舌比較大的半空心鋁型材模具壽命的設計方案,即將半空心型材模具設計成整體分流模的形式。
- With the increasing of the slenderness ratio, the influence of the loading method on the hooping effect and mechanical behavior of the members are decreased. 隨著長細比的增大,加載方式對試件套箍作用的影響有減小的趨勢,且受力性能的差異也逐漸縮小。
- The horizontal pressure vessels which have large slenderness ratio are supported on multi - saddles to reduce the numerical value of the moment and support pressure. 為降低彎矩和鞍座反力,長徑比大的臥式容器大多采用三鞍座或多鞍座支撐。
- Tests on rectangular CFDST beam-columns Considering the influences of slenderness ratio and load eccentricity, twelvetests on CFDST beam-columns were carried out. 考慮長細比、偏心率等參數,進行了12根矩形中空夾層鋼管混凝土構件、6根矩形實心鋼管混凝土構件和6根雙層空鋼管構件的偏心受壓試驗。
- Finally, a table of initial stress reduction factors with only two main parameters (initial stress degree and slenderness ratio) is given out to put in practice. 最后,以表格的形式給出僅含兩個主要參數(長細比和初應力度)的初應力度影響系數,以供工程中更加簡便、偏安全的應用。
- In this paper,the bearing capacity and failure modes of long angle steel truss concrete columns with different eccentricities and slenderness ratio are studied. 本文對不同偏心距和長細比的內含角鋼桁架混凝土長柱在偏心荷載作用下的承載力和破壞情況進行了研究。
- Since the slenderness ratio of femoral hip stem is very large, perform design is very important in material savings and cost reduction in the part family of hip stem. 由于人工關節股骨柄截面形狀及細長比差異很大,為考量鈦合金鍛造特性及省料化,預成形之設計相當重要;
- A total of 22 four-tube Concrete Filled Steel Tubular(CFST)laced columns are tested,with the experimental parameters being slenderness ratio and eccentricity. 進行共計22根四肢鋼管混凝土格構柱的極限承載力試驗,試驗參數為長細比和偏心率。
- Influences of slenderness ratio, eccentricity, steel-reinforced index and confining index on static performance of the eccentrically compressed STSRCH are analyzed too. 方法采用纖維模型法模擬組合柱的荷載-變形關系,分析長細比、偏心距、配骨指標和套箍指標對組合柱力學性能的影響。