您要查找的是不是：
- The connecting rod may drive a valve stem directly. 連桿可以直接帶動閥門的把柄。
- Replaceable hose filter and valve stem seals for field reliability. 可更換軟管過濾器和閥門閥桿密封,使得現場應用可靠行更高。
- For removal of valve stem seal and lower valve spring guide. 可用于拆卸汽門油封或降低汽門彈簧。
- Smooth operation of throttle linkage and throttle body air valve. 節流連桿和節流體空氣閥的平穩操作。
- Clean exposed portion of valve stem (Do not scratch). 清洗閥桿的外露部分(不要劃傷)。
- A valve stem has broken off and effectively seized up the engine. 閥桿折斷了，有效地阻止了發動機的運轉。
- Unthread the pump from the air valve and measure sag. 參考氣壓設定建議數值表打入相應氣壓以達到所需的預壓行程。
- Equipped with air valve to ejecting the products by blowing. 配備吹氣裝置以便于脫模。
- Valve stem 412 is dimensioned to attach to diaphragm 414, best seen in FIG. 2. 從圖二可見，閥桿412設計成能與隔膜414接合。
- Repeat steps2-5 until proper sag is achieved, then replace the air valve cap. 重復2－步驟以達到最佳預壓行程后，蓋上氣閥嘴帽。
- Pack a valve stem. 扎好活門塞
- Repeat steps 2-5 until proper sag is achieved, then replace the air valve cap. 重復2－5步驟以達到最佳預壓行程后，蓋上氣閥嘴帽。
- Locate the Schrader air valve on the shock and remove the air valve cap. 找到避震上的美嘴氣閥，取下氣閥帽。
- Inspect for scuffed or bent valve stems. 檢視氣門桿是否擦傷或彎曲。
- A tire tool or flat stock can be used to pry one part of the bead up over the rim flange( start near the valve stem). 可用輪胎工具或扁平的撬棒把輪緣的一端從輪輞輞圈上撬起。
- An overall air control for each pipe in each room is available by fitting an air valve at the hot water supply. 把空氣閥安裝在溫水供給器時可綜合處理各房間管路內的空氣。
- In a single-stage regulator, delivery pressure increases as cylinder pressure decays, because there is less gas pressure exerted on the valve stem. 在單級調整器里，輸出壓力隨鋼瓶壓力的減小而增大，這是因為施加在閥門系統上的氣體壓力減小了。
- The valve is switched on or off with difficulty. Please clear the paint on the valve stem and add some lubricant. 閥件開關太困難,請清除閥桿上的油漆并加潤滑劑。
- Technician was adjusting air valves on pallet elevator behind the safety guard. 該技工實際上是在調整安全裝置后面的托盤貨物升降機的氣閥。
- Turn the valve stem counterclockwise until the valve is fully open and will not turn any further. 逆時針旋轉閥桿直到閥門全開為止，不要旋轉過度。
