您要查找的是不是：
- AIR VALVE IS MADE UP OF UPPER VALVE SEAT, LOWER VALVE SEAT, 5 KINDS OF ACCURATE VALVE SLICE AND 25 SPRINGS. 該氣閥是由上閥座、下閥座及大小5種精密閥片和25個彈簧等零件組成。
- Clean or replace the relief valve seat. 清洗或更換安全閥閥座。
- Damage or fouled relief valve seat. 安全閥閥座損壞或受到污染。
- Damaged or fouled relief valve seat. 安全閥閥座受到損壞或污染。
- Place the relief valve seat back into the chamber bore. 將安全閥閥座放回到鏜孔內。
- Slide the diaphragm assembly into the relief valve seat. 將隔膜總成滑進到安全閥閥座內。
- Smooth operation of throttle linkage and throttle body air valve. 節流連桿和節流體空氣閥的平穩操作。
- Remove the pressed in relief valve seat and seat O-ring. 拆卸壓進去的安全閥閥座和閥座O形環。
- The maximum differential pressure across the valve seat. 通過閥門閥座的最大壓差。
- Unthread the pump from the air valve and measure sag. 參考氣壓設定建議數值表打入相應氣壓以達到所需的預壓行程。
- Equipped with air valve to ejecting the products by blowing. 配備吹氣裝置以便于脫模。
- Quick replaceable valve seat, convenient maintenance. 閥座可以快換，維修方便。
- Stellite takes a high polish and is used in steel valve seat rings. 鎢鉻鈷合金具有很高的拋光度，用作鋼閥門的閥座環。
- Repeat steps2-5 until proper sag is achieved, then replace the air valve cap. 重復2－步驟以達到最佳預壓行程后，蓋上氣閥嘴帽。
- Repeat steps 2-5 until proper sag is achieved, then replace the air valve cap. 重復2－5步驟以達到最佳預壓行程后，蓋上氣閥嘴帽。
- Locate the Schrader air valve on the shock and remove the air valve cap. 找到避震上的美嘴氣閥，取下氣閥帽。
- All valve seats and seat discs shall be replaceable. 所有閥門閥座和閥座閥瓣應該是可更換的。
- The exhaust valve seats skimmed up. 排氣閥座整新。
- Electrolysis of relief valve seat or first check seats. 安全閥閥座或第一止回閥閥座被電解或電蝕。
- An overall air control for each pipe in each room is available by fitting an air valve at the hot water supply. 把空氣閥安裝在溫水供給器時可綜合處理各房間管路內的空氣。
