您要查找的是不是：
- supply voltage rejection ratio 電源電壓抑制比
- Because the power supply rejection of most ADCs is fairly high, drifts in the power supply voltage do not adversely affect the measurement. 由于多數模數轉換器的電源濾波是相當高,電源電壓有害地偏差不影響這次測量。
- Power Supply Rejection: The ratio of the change in input offset voltage to change in power supply voltage producing it. 電源抑制比,輸入失調電壓變化量與引起該變化的電源電壓變化量之比。
- Ohmic resistance measured between the supply voltage connections. 供電電路中測得的電阻(歐姆)。
- Features: Low VCE(sat),High performance at low supply voltage. 特點：飽和壓降低,功率高和電壓小。
- R1 charges up the negative side of C1 to the supply voltage, VDD. R1將C1的負向充電到供電電壓VDD。
- This capacitance is discharged when the supply voltage is switched on. 為什么電源電壓接通時電容是放電?
- This equates to reclosing with twice the supply voltage on the motor. 這等于再合閘電機上有兩倍的電源電壓。
- Two wires for the supply voltage and one for the receiver's R/C sum signal. 通常沒有被引出，所以我們要打開接收機找到其中的那個焊點，將它引出。
- This paper presents a novel current source which is insensitive to supply voltage. 摘要這篇論文提出了一個和電源電壓變動無關的新式電流源。
- For mains-independent service in the field, the sensor can operate with a supply voltage of 6V. 傳感器獨立于主電源工作,可以在6伏的供電電壓下運行。
- The Voltage Selector Setting should be checked to see that it conforms to the local AC supply voltage. 必須查看本機交流電壓選擇器之預調狀態是否符合本地交流電壓。
- YOU MUST ENSURE THE BATTERY AND / OR POWER SUPPLY VOLTAGE DOES NOT EXCEED THE MAXIMUM SPECIFIED FOR YOUR SERVOS. 您必須保證電池和/ 或電源電壓不超出最大值被指定為您的伺服機。
- The power supply voltage may be controlled by replacing D1, D2, R1 and R2 with a variable voltage reference. 將D1、D2、R1和R2換成一個可變參考電壓源，本電路就變成了一個可控電源。
- The reference voltage, VREF, is applied externally and can be set up to the supply voltage, VDD. 基準電壓（VREF）由外部提供，最高可以設置為電源電壓VDD。
- Voltage generated by the motor at the instant of reclose may be equal to the supply voltage but exactly out of phase. 再合閘瞬間電機產生的電壓可與電源電壓相等但正好失相。
- However if the supply voltage or ambient temperature is low the machine still reduces input power at this preset time. 然而如果電壓或環境溫度低，機器仍要在這時減少能量輸入，就會(huì )導致烘焙時間長和“烤豆”。
- It is not necessary that AMPLIFIERs maintain common-mode rejection for signals beyond the supply voltages: what is required is that they do not self-destruct for momentary overvoltage conditions. 而信號遠離電源電壓后，再維持放大器的共模抑制是不必要的，需要的卻是不為瞬間過電壓所毀壞的條件。
- Supply voltage (effective value, frequency and waveform) for which the technical specifications of the force transducer apply. 力傳感器所使用的技術說明中所規定的供電電壓(有效值、頻率、波形)
- The required supply voltage shall be within the scope of changes to meet the standards in section 5.3 Of the basic functional requirements. 在規定電源電壓變化范圍內均應滿足本標準第5.;3條的基本功能要求。
