您要查找的是不是：
- CTT has only one measurement error in the test. 結果發現，CTT在整份測驗中只有一個測驗的誤差；
- This paper analyzes the static measurement and data processing of ballscrew. 通過實證分析,對滾珠絲桿靜態測量原始數據的處理方法進行探討。
- A parabola interpolation is used to reduce the measurement error. 采用拋物線插值計算互相關函數峰值,減少測量誤差。
- The result has good reproductivity and little measurement error. 該方法重現性好,測量誤差小。
- The static measurement includes weight, center of gravity, static lead lag, bending stiffness and torsion stiffness. 靜態測量包括重量，重心，靜前沿滯后，彎曲鋼度，和扭區鋼度。
- External proficiency testing also provides an ongoing comparison of inter-laboratory measurement error. 外部熟練鑒定還為實驗室內部測量誤差提供了時時比較程序。
- Custody transfer agreements call for the standardization of LNG static measurement, and it is recommended that the quantities be expressed in mass or energy units. 摘要按照LNG貿易協議要求標準化的靜態測量程序，推薦以質量或能量表示商品量。
- In experiment we estimate characteristics of semiconductor laser and EA-modulator by using photocurrent measurement of PIN diode and static measurement of broad area laser. 實驗部分我們利用PIN二極體光電流量測及寬面積雷射特性量測來估計調變器及雷射特性。
- Objective To introduce the basic theory of linear measurement error model and apply it to medical research. 目的介紹線性測量誤差模型的基本理論,探討它在醫學研究領域中的應用。
- The modulus of the sensor was measured directly by nano-indenter in the static measurement. 在靜態檢測實驗中，利用納米硬度計直接測出傳感器材料的彈性模量；
- A key component of this measurement error comes from the quality of the VNA calibration. 測量誤差的一個關鍵來源是失量網絡(luò )分析儀的校準質量。
- This new method can eliminate the measurement error of pulse oximetry theoretically. 目前的無創(chuàng )傷脈搏血氧飽和度測量是一種二波長確定血氧飽和度的方法。
- Even adjusting for measurement errors, these results are striking. 既使對統計誤差進行調整之后，這些結果也仍然是驚人的。
- Dynamic and static measurements of the pressure under the forefoot in patients with hallux valgus. 拇外翻病人的靜、動態前足底壓力測定。
- The performances of EMB system are directly affected by position measurement error. 在電磁軸承系統中,位置測量誤差直接影響著系統性能。
- A rough, static measure of a racquet's maneuverability based on weight and balance. 一個粗略的關于機動性的測量是基于質量和平衡的。
- The residual static measurements are able to be calculated by the residual static estimation. 經野外一次靜校正后,殘余的靜校正量可用剩余靜校正方法求出。
- The unique characteristics of ACQ are highly accurate and robust to the range measurement error. 它的主要特點是：可明顯提高感知精度，且對測距誤差具有很好的魯棒性。
- Phase-shift error is the main source of phase measurement error in phase-measuring profilometry(PMP). 移相誤差是移相法相位測量輪廓術的主要誤差來源。
- The site operation result shows that better gauging and satisfactory measurement accuracy of the said callipers can be achieved by means of thermal static measurement plus temperature compensation. 實踐證明，采用熱靜態測量加溫度補償的方法，較好地解決了測徑儀的標定，滿足了測量精度要求。
