您要查找的是不是：
- If MS DTC is not clustered, Setup fails. 如果MS DTC未設置群集,安裝程序將失敗。
- This will cause a MS DTC service restart. 這將使MS DTC服務重新啟動。
- IS THE RIGHT REAR SENSOR CIRCUIT FAILURE DTC PRESENT? 是否右后感知器電路故障DTC出現?
- This DTC showed no deoiling capability in wastewaters without Fe2+. 當污水中不含Fe2+時,DTC無絮凝除油效果。
- This paper analyzes the Direct Torque Control (DTC) theory of PMSM. 分析了永磁同步電機直接轉矩控制理論;
- Direct torque control (DTC) is a high performance control method. 直接轉矩控制(DTC)是一種高性能的控制方法。
- The observation error can meet the needs of the DTC system. 實測表明該模糊檢測器檢測誤差在工程允許范圍內。
- If SQL Server is installed on a cluster, MS DTC must be a cluster resource. 如果SQL Server安裝在群集上,則MS DTC必須是群集資源。
- UOW also can be obtained from the error log or through the MS DTC monitor. 也可從錯誤日志中或通過MS DTC監視器獲取UOW。
- Also can be obtained from the error log or through the MS DTC monitor. 也可從錯誤日志中獲得,或通過DTC監視器獲得。
- The basic principles of the direct torque control (DTC) were simply presented. 闡述了直接轉矩控制(DTC)的基本原理。
- Low-speed performance is a bottleneck of direct torque control (DTC) method. 低速性能是直接轉矩控制（DTC）方法的瓶頸。
- The flocculation processes by DTC in the presence of Fe2+ were discussed. 討論了DTC在Fe2+參與下的絮凝過程。 圖5表1參8。
- Simulation results testify the DTC has good static and dynamic performance. 并進行了仿真，仿真結果驗證了直接轉矩控制優良的動靜態性能。
- DTC water clarifiers are featured by their high oil removing capacity. 同常規凈水劑相比，二硫代氨基甲酸鹽具有除油效率高的特點。
- The fault diagnosis switch is for reading diagnostic trouble code (DTC) only. 故障診斷開關只供讀取故障碼時使用。
- Compared with the previous version, the DTC display for No.00137 has been changed. 與前一版本相比改變了故障碼00137的顯示。
- To resolve, either fix MS DTC, restore from a full backup, or repair the database. 要解決此問題,或者修復MS DTC,從完整備份恢復,或者修復數據庫。
- Microsoft recommends that you put MS DTC in its own group with its own physical disk resource, if it is possible. Microsoft建議盡可能將MS DTC放在自己的組和自己的物理磁盤資源中。
- DTC Digital Transmit Command. The command response to the capabilities identified by the DIS signal. 數字化傳輸命令:該命令對由DIS信號識別的功能進行響應。
