您要查找的是不是：
- Cavitation can be caused by a variety of reasons. 氣穴可以由各種原因引起。
- Cavitation is noisy and easily detected by sonar. 空泡現象是有噪聲的并且容易被聲納探測到。
- It explores the most conditions of cavitation. 探索了最優空化強化條件。
- Areas of necrosis and cavitation may occur within the tumor. 腫瘤內可以有壞死和成腔區。
- This is the basis of the phenomenon called cavitation. 這就是所謂汽蝕現象的根據。
- The total diameter of cavitation, if present, is less than 4cm. 若出現空洞，其直徑總和小于4厘米。
- Excessive noise is an indication that cavitation is occurring. 噪音太大是發生空洞現象的一個征兆。
- Flow metering installation shall not cause flashing or cavitation. 流量表的安裝不應引起閃蒸或氣蝕。
- Cavitation damage was uneven and cavities appeared in local places. 空蝕破壞呈現不均勻性,局部區域出現大的空蝕坑。
- This is the basis of the phenomenon called cavitation . 這就是所謂汽蝕現象的根據。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 對于不可壓縮性流體,如果壓降產生空穴或閃蒸。
- Excessive fluid noise is usually an indication that cavitation is occurring. 如果流體噪音過大,則通常意味著出現氣穴現象。
- In both silicosis and CWP, these masses can undergo necrosis and cavitation. 無論硅肺還是CWP的大結節團塊都可以出現壞死和空洞。
- Extremely high velocities should be avoided due to possible cavitation. 應該避免應用在可能出現空穴現象的流速異常高速的場合。
- No cavitation, lymphadenopathy, or pleural effusion was demonstrated. 經過證明沒有空洞，淋巴結大和胸膜滲出。
- Design of the WATTS Automatic Control Valve minimizes potential valve damage that can be caused by cavitation. 美國瓦茨自動控制閥的結構將可能導致空穴現象的閥門損壞潛在危險降低到最小程度。
- The Mechanism Analysis of Control Valve Cavitation and the Measures to Avoid It. 控制閥氣蝕機理分析及防止措施研究。
- Hydrodynamic cavitation as a tool to control macro-, micro-, and nano-properties of inorganic materials. 以液力氣蝕作用調控無機材料之宏觀、微觀及納米特性。
- The method of avoiding agglomeration by ultrasonic cavitation is proposed to obtain ideal nanomaterials. 提出利用超聲的空化作用來有效地防止團聚現象，以期得到理想的納米材料。
- In addition, the effect of distribution of cavitation on the spout pressure is analysed. 進一步分析了不同燃油噴射壓力對噴孔內空穴分布的影響。
