您要查找的是不是：
- That pipe thread is bad. Use another one instead. 那個鉆桿的絲扣壞了,換另外一根。
- A 3/4" NPT pipe thread has an outside diameter - OD - of 1.050 inches. 例如：一個標準為3/4"NPT的管外部直徑為1.;050英寸。
- Schroeder SKB's are available with pipe thread connections s ranging from 1 to 3 inches. 施羅德SKB的管螺紋連接s不等，從1至3英寸。
- Drill pipe threads are not cleaned in that way. 鉆桿絲扣不是那樣清洗的。
- Due to the existence of electric submersible pump Kau, so connected in the pipe thread Department has set up anti-down block. 因電潛泵存在倒扣問題，所以在管螺紋聯接處設置了防倒塊。
- Apply pipe dope sparingly on pipe threads, never on valve threads. 在管道螺紋上涂敷螺紋油，但是不要在閥門螺紋上涂螺紋油。
- Needle valves have NPS / internal pipe threaded ends. 針形閥配置NPS內管螺紋連接端口。
- Tapered pipe threads produce radial stress in female fittings. 錐管螺紋在內螺紋內會(huì )產生徑向應力。
- If pipe dope is used, apply sparingly on pipe threads, neveron valve threads. 在管道螺紋上只能少量使用管道粘接劑，但是在閥門螺紋上絕對不能使用管道粘接劑。
- Specifes basic thread form, taper, and tolerances of general purpose tapered pipe threads (metal). 規范通用錐管螺紋（金屬）的基本螺紋形式，錐度，以及公差。
- If the drill pipe threads become rusty, rust will have to be cleaned. 如果鉆桿絲扣生銹,必須清除掉。
- Talking abaut pipe thread and its application 談?wù)劰苈菁y及其應用
- Taper pipe thread for general purpose ( Old 一般用途錐管螺紋(舊代號
- It may take an hour to wind off all the thread. 把所有線都松下需一個小時。
- Expand of Machining Range of Pipe Thread Lathe 管子螺紋車床加工范圍的擴充
- The thread seems to match the cloth. 這線和這布似乎很相稱。
- American Standard Taper Pipe Thread 布氏錐管螺紋
- Specifications ranging form 15mm to 150mm. The pipe threads have two systems: English and American. 規格由15MM150MM，管件分英制和美制螺紋兩種。
- How many spools of thread did you use? 你用了幾軸線?
- When threading pipe, gauge pipe threads for size and length to avoid jamming pipe against seat and disc. 當對管道進行攻絲時，要測定管道螺紋的尺寸和長度，避免將管道塞滿閥座和閥瓣。
