您要查找的是不是：
- blade thickness ratio 翼厚比
- The following photos show the blade thickness and distal taper. 以下的是比較不同刀劍的刃厚及其變化。
- Besides, the blade contacts and handling were better simulated too due to the reduced blade thickness. 而且兵刃相交及揮舞也由于厚度減少而能模擬得更真實。
- Leaf blade thickly papery, glabrous. 葉片厚紙質，無毛。
- The influence of blade thickness and torsion on the flow field at low Reynolds number for rotor in a hover is studied with the Chimera grid technique. 摘要運用嵌套網格技術研究了漿葉的厚度和扭轉對低雷諾數旋翼流場的影響。
- Finally, single sand bodies were correlated by using model, lithology and thickness ratio. 最后利用模型以及巖性和厚度比例對比單砂層。
- Previous research has shown that thickness ratio,main strain and rolling direction influences the FLD of TWBs. 當前國外學者初步研究了材料厚度比、載荷形式、軋制方向等若干因素對拼焊板成形極限的影響規律;
- Leaf blade thick papery, adaxially woolly, glabrescent; corolla glabrous outside; ovary glabrous; peduncle 3-21 cm; pedicel 0.5-2 cm. 葉片厚紙質，正面具綿狀毛，；無毛的花冠在外面；子房無毛花序梗3-21厘米；花梗0.;5-2厘米(21
- The study also showed that the determinant of lift was not the thickness ratio, but the angle of attack, the relative camber and the camber line. 這些方法得到的結果一致證實產生升力的因素不是單純的相對厚度，而是迎角、翼型相對彎度以及中弧線。
- The results indicate that the formability of laser tailored blank depends on the intensity and thickness ratio of two kind blanks. 研究結果表明,對不同材質和不同厚度的拼焊板,零件的變形取決于兩種材料的強度比和厚度比。
- The purpose of this paper was to validate the effects of airfoil thickness ratio on the characteristics of a family of airfoils. 本文采用不同的方法驗證了相對厚度對機翼氣動特性的影響。
- Considering both the machining capability and strength requirement, the blade thickness distribution is proposed as the design variable to be optimized with the response surface method. 結合上述葉片的特點幷考慮到加工的方便性和強度要求，以葉片厚度分布為設計變量，用響應面方法進行了優化設計。
- The best protection，as evinced with EIS, was obtained for the coating systems with the thickness ratio of primer/topcoat about 2:1. 且當環氧富鋅底漆為涂層總厚度的2/3左右時，涂層體系的防護性能最好。
- By discussing the influences of the ratio on forces,friction,wear and strength of the vanes,the suitable thickness ratio of the double decked vane compressor had been optimized. 上層滑片與下層滑片的厚度比是雙層滑片壓縮機的重要結構參數，通過對不同厚度比的雙層滑片結構的受力狀況、摩擦磨損及強度的分析比較，找出了厚度比的適宜值。
- B.8.7) Cracks are evaluated according to crack length ratio (CLR) and crack thickness ratio (CTR) by measuring the total crack length and extend of stepwise cracking respectively. 根據裂紋長度率（CLR）和裂縫厚度率（CTR），通過測量總裂紋長度和分別擴大逐步龜裂，對裂縫進行鑒定。
- The area of hiatus and the muscular thickness of the crura increased with age.The hiatus area to crura muscle thickness ratio decreased with age (P＜0.05). 食管裂孔面積和肌厚隨嬰兒年齡而逐漸增加，而裂孔肌相對厚度與胎兒組比較均減少(P＜0.;05)。
- Leaf blade thickly leathery, apex acute or obtuse. Cymose panicles less than 10 cm. Sepals ovate. 葉片厚革質，先端銳尖的或鈍。密傘圓錐花序不到10厘米萼片卵形。
- The thickness ratio appeared to have little effect on lift coefficient at zero angle of attack, since the angle of zero lift was largely determined by the airfoil camber. 在迎角為零時，由于零升力主要由機翼中弧線決定，相對厚度對升力幾乎沒有影響。
- Current year branchlets stout, 2-ribbed; leaf blade thickly leathery, abaxially reddish brown when dry; sepals pubescent. 當年小枝粗壯，2肋；干燥時的葉片厚革質，背面的紅棕色；萼片短柔毛。
- The results showed that the effects of traverse shear on displacement and strees are not ignorable,as the length thick ratio of laminate is less than 30. 結果表明：四邊鉸支的正交異性層合板，當其長厚比小于30時，橫向剪切變形對其位移和應力的影響是不容忽略的。
